- Rigid chassis
- WhichTractor size: Standard-size
- Not independently tested
- 1993–1995
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Deutz-Fahr AgroStar 6.08 Full specifications
KHD F6L 913 six-cylinder diesel. The manufacturer claimed 105.7 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
105.7 hp
78.8 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”, claimed
- Weight
- 10,009 lb
- 3-point lift
- 11,464 lb
- Hyd. flow
- 15.2 gpm
- Top speed
- 18.6–24.9 mph
Deutz-Fahr AgroStar 6.08 specs: key facts
The Deutz-Fahr AgroStar 6.08 was built from 1993 to 1995.
The Deutz-Fahr AgroStar 6.08 has a claimed engine power (gross or net not stated) of 78.8 kW (105.7 hp); it has no measured PTO figure.
The Deutz-Fahr AgroStar 6.08 is four-wheel drive (4WD).
The Deutz-Fahr AgroStar 6.08 has a KHD F6L 913 engine, a 6-cylinder 6.13 L diesel unit.Source 2
The Deutz-Fahr AgroStar 6.08 weighs 4,540 kg (10,009 lb) unladen.
The Deutz-Fahr AgroStar 6.08 has an independent rear PTO running at 540/1000/750 rpm.
The three-point hitch of the Deutz-Fahr AgroStar 6.08 lifts 5,200 kg (11,464 lb) at the lower-link ends.
The hydraulic pump of the Deutz-Fahr AgroStar 6.08 delivers 57.5 L/min (15.2 gpm).
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”
How much horsepower does an AgroStar 6.08 have?
The only figure for the AgroStar 6.08 is 105.7 hp (78.8 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”
What engine is in an AgroStar 6.08?
An AgroStar 6.08 has a KHD F6L 913, a 6-cylinder 6.13 L diesel engine.
| Make & model | KHD F6L 913 |
|---|---|
| Cylinders | 6, air-cooledSource 1 |
| Displacement | 374.0 ci · 6.13 L |
| Max torque | 282 lb·ft · 382 N·m @ 1,600 rpmSource 1 |
Source · Traktorenlexikon, “Deutz-Fahr DX 120”
How much will an AgroStar 6.08 lift, and what is its hydraulic flow?
An AgroStar 6.08 lifts 11,464 lb (5,200 kg) at the lower-link ends of its Category 2 three-point hitch.
| Pump flow | 15.2 gpm · 57.5 L/min |
|---|---|
| Hitch category | Category 2 |
| Lift at ends | 11,464 lb · 5,200 kg |
| Rear PTO | Independent, 540/1000/750 rpm @ 2,121 engine rpmEngages under load |
| PTO shaft | 1 3/8"- 6 splines (Form-1) |
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”
What transmission does an AgroStar 6.08 have?
Transmission specifications for the AgroStar 6.08 are below.
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
|---|
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”
How much does an AgroStar 6.08 weigh?
An AgroStar 6.08 weighs 10,009 lb (4,540 kg) unladen.
| Unladen weight | 10,009 lb · 4,540 kg |
|---|---|
| Maximum permissible mass | 18,739 lb · 8,500 kg |
| Maximum front axle load | 7,716 lb · 3,500 kg |
| Maximum rear axle load | 14,330 lb · 6,500 kg |
| Wheelbase | 107.0 in · 2,718 mm |
| Length | 179.4 in · 4,556 mm |
| Width | 90.2 in · 2,290 mm |
| Height | 110.9 in · 2,818 mm |
| Ground clearance | 20.9 in · 530 mm |
| Front track | 63.0–70.9 in · 1,600–1,800 mmthe article lists alternatives |
| Rear track | 59.1–70.9 in · 1,500–1,800 mmthe article lists alternatives |
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”
Which tractors compare with an AgroStar 6.08?
Within 10% of its 105.7 hp of claimed engine power, the same type, and first built within 15 years of it.
- Massey Ferguson MF 3095 (A)105.5 hp engine, claimed · 1990–1995Side by side with the AgroStar 6.08 →
- DEUTZ-ALLIS 8010105.5 hp engine, claimed · 1985–1988Side by side with the AgroStar 6.08 →
- AGRIFULL 80-105 DT105.5 hp engine, claimed · 1980–1986Side by side with the AgroStar 6.08 →
- VALMET 1103/1103-4105.5 hp engine, claimed · 1979–1980Side by side with the AgroStar 6.08 →
- WHITE 6105106.5 hp engine, claimed · 1992–1997Side by side with the AgroStar 6.08 →
- Renault Temis 610107.5 hp engine, claimed · 1999–2005Side by side with the AgroStar 6.08 →
Everything else people ask
Is an AgroStar 6.08 two-wheel drive or four-wheel drive?
The Deutz-Fahr AgroStar 6.08 is four-wheel drive (4WD).
What PTO does an AgroStar 6.08 have?
An AgroStar 6.08 has a independent 540/1000/750 rpm rear PTO on a 1 3/8"- 6 splines (Form-1) shaft.
Where this page comes from
Compiled from Traktorenlexikon, “Deutz-Fahr DX 120”; and Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Deutz-Fahr AgroStar 6.08 — CC BY-SA 4.0, WIKIBOOKS-TL-80213 · revision 1077902. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: Deutz-Fahr DX 120 — CC BY-SA 4.0, WIKIBOOKS-TL-59145 · revision 1089854. Wikibooks contributors (Traktorenlexikon). Original document