7 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 80101985–1988No measured PTO figureTractor twoDeutz-Fahr AgroStar 6.081993–1995No measured PTO figure
Which should you choose?
Read our verdict on the 8010 and the AgroStar 6.08 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 8010 | AgroStar 6.08 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 105.5 hp | 105.7 hp | — |
| Engine declared | ALLIS-CHALMERS 649 T | KHD F6L 913 | differs |
| Displacement declared | 4.93 L | 6.13 L | +24% AgroStar 6.08 |
| Maximum torque declared | — | 282 lb·ft · 382 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 45.0 gpm · 170.3 L/min | 15.2 gpm · 57.5 L/min | +196% 8010 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000/750 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,630 lb · 5,729 kg | 10,009 lb · 4,540 kg | +26% 8010 |
| Maximum permissible mass declared | — | 18,739 lb · 8,500 kg | — |
| Wheelbase declared | 106.0 in · 2,692 mm | 107.0 in · 2,718 mm | — |
| Length declared | 187.0 in · 4,750 mm | 179.4 in · 4,556 mm | — |
| Width declared | 92.6 in · 2,352 mm | 90.2 in · 2,290 mm | — |
| Height, over the cab declared | 114.0 in · 2,896 mm | 110.9 in · 2,818 mm | — |
| Ground clearance declared | 21.0 in · 533 mm | 20.9 in · 530 mm | — |
| Turning radius, braked declared | 12.0 ft · 3.67 m | — | — |
| Fuel tank declared | 239.9 qt · 227.0 L | 179.6 qt · 170 L | +34% 8010 |
DEUTZ-ALLIS 8010 sources
Source
- Source: Traktorenlexikon, “Deutz-Allis 8010”
Deutz-Fahr AgroStar 6.08 sources
Source
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 6.08”
- Source: Traktorenlexikon, “Deutz-Fahr DX 120”