- Rigid chassis
- WhichTractor size: Standard-size
- No lab test on file
- 1993–1995
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Deutz-Fahr AgroStar 6.28 specs: hp, weight, years
KHD F6L 913 six-cylinder diesel. The manufacturer claimed 113.5 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
113.5 hp
84.6 kW as stated by the source
No lab test on file
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”, claimed
This is the maker’s own figure, measured at the engine. Power at the PTO is lower — by how much, for this machine, nobody has measured.
- Weight
- 10,229 lb
- 3-point lift
- 14,330 lb
- Hyd. flow
- 14.5 gpm
- Top speed
- 18.6–24.9 mph
Deutz-Fahr AgroStar 6.28 specs: key facts
The Deutz-Fahr AgroStar 6.28 was built from 1993 to 1995.
The Deutz-Fahr AgroStar 6.28 has a claimed engine power (gross or net not stated) of 84.6 kW (113.5 hp); it has no measured PTO figure.
The Deutz-Fahr AgroStar 6.28 is four-wheel drive (4WD).
The Deutz-Fahr AgroStar 6.28 has a KHD F6L 913 engine, a 6-cylinder 6.13 L diesel unit.Source 2
The Deutz-Fahr AgroStar 6.28 weighs 4,640 kg (10,229 lb) unladen.
The Deutz-Fahr AgroStar 6.28 has an independent rear PTO running at 540/1000/750 rpm.
The three-point hitch of the Deutz-Fahr AgroStar 6.28 lifts 6,500 kg (14,330 lb) at the lower-link ends.
The hydraulic pump of the Deutz-Fahr AgroStar 6.28 delivers 55.0 L/min (14.5 gpm).
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
How does the AgroStar 6.28 compare with its class?
- Limitation:
A maximum engine torque of 348 N·m is low for its class — 18% below the median of 422 N·m across the 239 machines within 10% of its power that hold this figure.
- Strength:
40 forward gears is high for its class — 150% above the median of 16 across the 260 machines within 10% of its power that hold this figure.
- Limitation:
The power figure is a manufacturer claim, not a measurement. No laboratory test report exists for this machine. Of the 287 tractors within 10% of its power, 10% carry one.
Derived by WhichTractor from 287 comparable records. How we work this out

How much horsepower does an AgroStar 6.28 have?
The only figure for the AgroStar 6.28 is 113.5 hp (84.6 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
What engine is in an AgroStar 6.28?
An AgroStar 6.28 has a KHD F6L 913, a 6-cylinder 6.13 L diesel engine.
| Make & model | KHD F6L 913Source 2 |
|---|---|
| Cylinders | 6, air-cooledSource 2 |
| Displacement | 374.0 ci · 6.13 LSource 2 |
| Max torque | 257 lb·ft · 348 N·m @ 1,600 rpm |
| Injection | direct injection |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
How much will an AgroStar 6.28 lift, and what is its hydraulic flow?
An AgroStar 6.28 lifts 14,330 lb (6,500 kg) at the lower-link ends of its Category 2 three-point hitch.
| Pump flow | 14.5 gpm · 55.0 L/min |
|---|---|
| Hitch category | Category 2 |
| Lift at ends | 14,330 lb · 6,500 kg |
| Rear PTO | Independent, 540/1000/750 rpmEngages under load |
| PTO shaft | 1 3/8"- 6 splines (Form-1) |
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
What transmission does an AgroStar 6.28 have?
Transmission specifications for the AgroStar 6.28 are below.
| Clutch | dry single clutch |
|---|---|
| Brakes | hydraulically operated dry fixed-caliper disc brake outside the transmission housing |
| Steering | hydrostatic ZF steering |
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
How much does an AgroStar 6.28 weigh?
An AgroStar 6.28 weighs 10,229 lb (4,640 kg) unladen.
| Unladen weight | 10,229 lb · 4,640 kg |
|---|---|
| Maximum permissible mass | 18,739 lb · 8,500 kg |
| Maximum front axle load | 7,716 lb · 3,500 kg |
| Maximum rear axle load | 14,330 lb · 6,500 kg |
| Wheelbase | 107.0 in · 2,718 mm |
| Length | 179.4 in · 4,556 mm |
| Width | 97.2 in · 2,470 mm |
| Height | 110.9 in · 2,818 mm |
| Ground clearance | 20.9 in · 530 mm |
| Front track | 63.0–70.9 in · 1,600–1,800 mmthe article lists alternatives |
| Rear track | 59.1–70.9 in · 1,500–1,800 mmthe article lists alternatives |
Source · Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
What oil does an AgroStar 6.28 take, and how much?
An AgroStar 6.28 engine takes 16.9 qt (16 L). Single source, not independently verified — always confirm against the operator’s manual for your machine.
| System | Capacity |
|---|---|
| Engine oil | 16.9 qt · 16 LSource: Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” · single source, not independently verified |
| Transmission | 46.5 qt · 44 LSource: Traktorenlexikon, “Deutz-Fahr AgroStar 6.28” · single source, not independently verified |
Always confirm against the operator’s manual for your machine before service.
Which tractors compare with an AgroStar 6.28?
Within 10% of its 113.5 hp of claimed engine power, the same type, and first built within 15 years of it.
- Fiat F-115 DT113.5 hp engine, claimed · 1993–1996Side by side with the AgroStar 6.28 →
- Case-Steyr 9115a113.5 hp engine, claimed · 1995–2003Side by side with the AgroStar 6.28 →
- Deutz-Fahr Agrotron 6.20113.5 hp engine, claimed · 1995–1997Side by side with the AgroStar 6.28 →
- Lamborghini 115 DT Formula113.5 hp engine, claimed · 1991–1996Side by side with the AgroStar 6.28 →
- Fiat M 115113.5 hp engine, claimed · 1996–1999Side by side with the AgroStar 6.28 →
- Lamborghini 115 DT Formula113.5 hp engine, claimed · 1996–2000Side by side with the AgroStar 6.28 →
Common questions about the Deutz-Fahr AgroStar 6.28
Is an AgroStar 6.28 two-wheel drive or four-wheel drive?
The Deutz-Fahr AgroStar 6.28 is four-wheel drive (4WD).
What PTO does an AgroStar 6.28 have?
An AgroStar 6.28 has a independent 540/1000/750 rpm rear PTO on a 1 3/8"- 6 splines (Form-1) shaft.
Sources and how this page was built
Compiled from Traktorenlexikon, “Deutz-Fahr DX 120”; and Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Deutz-Fahr AgroStar 6.28 — CC BY-SA 4.0, WIKIBOOKS-TL-87906 · revision 828531. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: Deutz-Fahr DX 120 — CC BY-SA 4.0, WIKIBOOKS-TL-59145 · revision 1089854. Wikibooks contributors (Traktorenlexikon). Original document