• Rigid chassis
  • WhichTractor size: Utility
  • Not independently tested
  • 1954–1957
  • 2,871 built

WhichTractor size, not the maker’s category

Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is

Fahr D 130 Full specifications

Güldner 2 LD two-cylinder diesel. The manufacturer claimed 16.8 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.

Engine power, claimed · gross or net not stated

16.8 hp

12.5 kW as stated by the source

Not independently tested

Claimed · standard not stated by the source

Source · Traktorenlexikon, “Fahr D 130”, claimed

Weight
2,624 lb
Top speed
11.7 mph

Fahr D 130 specs: key facts

  • The Fahr D 130 was built from 1954 to 1957.

  • The Fahr D 130 has a claimed engine power (gross or net not stated) of 12.5 kW (16.8 hp); it has no measured PTO figure.

  • The Fahr D 130 is two-wheel drive (2WD).

  • The Fahr D 130 has a Güldner 2 LD engine, a 2-cylinder 1.31 L diesel unit.Source 2

  • The Fahr D 130 weighs 1,190 kg (2,624 lb) unladen.

  • The Fahr D 130 has a rear PTO running at 588 rpm.

Source · Traktorenlexikon, “Fahr D 130”

Fahr D 130 tractor
Photo: High Contrast, CC BY 3.0 de via Wikimedia Commons · Wrong photo?

How much horsepower does a D 130 have?

The only figure for the D 130 is 16.8 hp (12.5 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.

Engine, claimed (gross/net not stated)
16.8 hp

Source · Traktorenlexikon, “Fahr D 130”

What engine is in a D 130?

A D 130 has a Güldner 2 LD, a 2-cylinder 1.31 L diesel engine.

Engine — D 130 engine specifications
Make & modelGüldner 2 LDSource 2
Cylinders2, air-cooledSource 2
Displacement79.6 ci · 1.31 LSource 2
Max torque48 lb·ft · 65 N·m @ 1,700 rpm
Electrical system12 V

Source · Traktorenlexikon, “Fahr D 130”

How much will a D 130 lift?

Hydraulic and PTO specifications for the D 130 are below.

Hydraulics & PTO — D 130 hydraulics and PTO specifications
Pressure3,129 psi · 216 bar
Rear PTO588 rpm
PTO shaft29 x 34,9 x 8,7 mm

Source · Traktorenlexikon, “Fahr D 130”

What transmission does a D 130 have?

Transmission specifications for the D 130 are below.

Transmission — D 130 transmission specifications
SteeringZF steering type EL-10 604
Top speed11.7 mph · 18.8 km/h

Source · Traktorenlexikon, “Fahr D 130”

How much does a D 130 weigh?

A D 130 weighs 2,624 lb (1,190 kg) unladen.

Weights & dimensions — D 130 weights and dimensions
Unladen weight2,624 lb · 1,190 kg
Maximum permissible mass3,748 lb · 1,700 kg
Maximum front axle load1,543 lb · 700 kg
Maximum rear axle load2,205 lb · 1,000 kg
Wheelbase65.6 in · 1,665 mm
Length104.7 in · 2,660 mm
Width64.4 in · 1,636 mm
Height59.7 in · 1,516 mm
Ground clearance14.2 in · 361 mm
Front track48.2–75.7 in · 1,224–1,924 mmWikibooks gives one track for both axles
Rear track48.2–75.7 in · 1,224–1,924 mmWikibooks gives one track for both axles
Turning radius, braked8.1 ft · 2.48 m

Source · Traktorenlexikon, “Fahr D 130”

Which tractors compare with a D 130?

Within 10% of its 17 hp at the PTO (claimed), the same type, and first built within 15 years of it.

Everything else people ask

Is a D 130 two-wheel drive or four-wheel drive?

The Fahr D 130 is two-wheel drive (2WD).

What PTO does a D 130 have?

A D 130 has a 588 rpm rear PTO on a 29 x 34,9 x 8,7 mm shaft.

Where this page comes from

Compiled from Traktorenlexikon, “Fahr D 131 L”; and Traktorenlexikon, “Fahr D 130”.

Last verified

Not yet verified

Spotted an error?

Sources

Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution

  1. Traktorenlexikon: Fahr D 130CC BY-SA 4.0, WIKIBOOKS-TL-46964 · revision 990493. Wikibooks contributors (Traktorenlexikon). Original document
  2. Traktorenlexikon: Fahr D 131 LCC BY-SA 4.0, WIKIBOOKS-TL-43364 · revision 1043101. Wikibooks contributors (Traktorenlexikon). Original document