- Rigid chassis
- WhichTractor size: Standard-size
- No lab test on file
- 1986–1989
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
DEUTZ-ALLIS 7110 specs: hp, weight, years
The manufacturer claimed 110.5 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
110.5 hp
82.4 kW as stated by the source
No lab test on file
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Deutz-Allis 7110”, claimed
This is the maker’s own figure, measured at the engine. Power at the PTO is lower — by how much, for this machine, nobody has measured.
- Weight
- 9,700 lb
- 3-point lift
- 11,464 lb
- Hyd. flow
- 24.0 gpm
- Top speed
- 18.6 mph
DEUTZ-ALLIS 7110 specs: key facts
The DEUTZ-ALLIS 7110 was built from 1986 to 1989.
The DEUTZ-ALLIS 7110 has a claimed engine power (gross or net not stated) of 82.4 kW (110.5 hp); it has no measured PTO figure.
The DEUTZ-ALLIS 7110 was offered in two-wheel-drive and four-wheel-drive versions.
The DEUTZ-ALLIS 7110 weighs 4,400 kg (9,700 lb) unladen.
The DEUTZ-ALLIS 7110 has an independent rear PTO running at 540/1000 rpm.
The three-point hitch of the DEUTZ-ALLIS 7110 lifts 5,200 kg (11,464 lb) at the lower-link ends.
The hydraulic pump of the DEUTZ-ALLIS 7110 delivers 90.8 L/min (24.0 gpm).
Source · Traktorenlexikon, “Deutz-Allis 7110”
How does the 7110 compare with its class?
- Limitation:
A 117 L fuel tank is low for its class — 35% below the median of 180 L across the 246 machines within 10% of its power that hold this figure.
Derived by WhichTractor from 264 comparable records. How we work this out
How much horsepower does a 7110 have?
The only figure for the 7110 is 110.5 hp (82.4 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Deutz-Allis 7110”
How much will a 7110 lift, and what is its hydraulic flow?
A 7110 lifts 11,464 lb (5,200 kg) at the lower-link ends.
| System | Open centre |
|---|---|
| Pump flow | 24.0 gpm · 90.8 L/min |
| Pressure | 3,481 psi · 240 bar |
| Lift at ends | 11,464 lb · 5,200 kg |
| Rear PTO | Independent, engine-driven, 540/1000 rpm @ 2,192 engine rpm |
| PTO shaft | 1 3/8"- 6 splines and 1 3/8"- 21 parts |
Source · Traktorenlexikon, “Deutz-Allis 7110”
What transmission does a 7110 have?
Transmission specifications for the 7110 are below.
| Clutch | Independent dry double clutch |
|---|---|
| Steering | Hydrostatic Danfoss steering, type OSPC-140 OR |
| Top speed | 18.6 mph · 30 km/h |
Source · Traktorenlexikon, “Deutz-Allis 7110”
How much does a 7110 weigh?
A 7110 weighs 9,700 lb (4,400 kg) unladen.
| Unladen weight | 9,700 lb · 4,400 kg4 WD: 4,840 kg |
|---|---|
| Wheelbase | 105.8 in · 2,687 mm4 WD: 2,703 |
| Length | 176.8 in · 4,490 mm |
| Width | 90.5 in · 2,299 mm |
| Height | 107.3 in · 2,725 mm |
| Ground clearance | 24.4 in · 620 mm4 WD: 540 |
| Front track | 64.0–88.0 in · 1,626–2,235 mm1,800-2,000 |
| Rear track | 64.0–88.0 in · 1,626–2,235 mm |
Source · Traktorenlexikon, “Deutz-Allis 7110”
What oil does a 7110 take, and how much?
A 7110 engine takes 18.0 qt (17.0 L). Single source, not independently verified — always confirm against the operator’s manual for your machine.
| System | Capacity |
|---|---|
| Engine oil | 18.0 qt · 17.0 LSource: Traktorenlexikon, “Deutz-Allis 7110” · single source, not independently verified |
| Transmission | 52.0 qt · 49.2 LSource: Traktorenlexikon, “Deutz-Allis 7110” · single source, not independently verified |
| Hydraulic | 13.9 qt · 13.2 LSource: Traktorenlexikon, “Deutz-Allis 7110” · single source, not independently verified |
| Front axle | 7.9 qt · 7.5 LSource: Traktorenlexikon, “Deutz-Allis 7110” · single source, not independently verified |
Always confirm against the operator’s manual for your machine before service.
Which tractors compare with a 7110?
Within 10% of its 110.5 hp of claimed engine power, the same type, and first built within 15 years of it.
- J.I. Case 1694110.5 hp engine, claimed · 1984–1985Side by side with the 7110 →
- AGCO-ALLIS 8785110.5 hp engine, claimed · 1998–1999Side by side with the 7110 →
- WHITE 6810110.5 hp engine, claimed · 1998–2001Side by side with the 7110 →
- John Deere 3255109.6 hp engine, claimed · 1991–1993Side by side with the 7110 →
- Massey Ferguson 3610111.6 hp engine, claimed · 1987–1990Side by side with the 7110 →
- Deutz-Fahr AgroStar 6.21111.6 hp engine, claimed · 1992–1993Side by side with the 7110 →
Common questions about the DEUTZ-ALLIS 7110
Is a 7110 two-wheel drive or four-wheel drive?
The DEUTZ-ALLIS 7110 was offered in two-wheel-drive and four-wheel-drive versions.
What PTO does a 7110 have?
A 7110 has a independent 540/1000 rpm rear PTO on a 1 3/8"- 6 splines and 1 3/8"- 21 parts shaft.
Sources and how this page was built
Compiled from Traktorenlexikon, “Deutz-Allis 7110”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Deutz-Allis 7110 — CC BY-SA 4.0, WIKIBOOKS-TL-122415 · revision 1083338. Wikibooks contributors (Traktorenlexikon). Original document