9 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 71101986–1989No measured PTO figureTractor twoDeutz-Fahr AgroStar 6.211992–1993No measured PTO figure
Which should you choose?
Read our verdict on the 7110 and the AgroStar 6.21 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 7110 | AgroStar 6.21 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 110.5 hp | 111.6 hp | — |
| Engine declared | — | KHD F6L 913 | — |
| Displacement declared | — | 6.13 L | — |
| Maximum torque declared | 281 lb·ft · 381 N·m | 285 lb·ft · 387 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Independent dry double clutch | Pedal-operated single-disc dry clutch with 330 mm disc diameter | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 24.0 gpm · 90.8 L/min | 14.8 gpm · 56.0 L/min | +62% 7110 |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Three-point lift, at the coupling points declared | 11,464 lb · 5,200 kg | 14,330 lb · 6,500 kg | +25% AgroStar 6.21 |
| Rear PTO speeds declared | 540/1000 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,700 lb · 4,400 kg | 10,229 lb · 4,640 kg | +5% AgroStar 6.21 |
| Maximum permissible mass declared | — | 18,739 lb · 8,500 kg | — |
| Wheelbase declared | 105.8 in · 2,687 mm | 107.0 in · 2,718 mm | — |
| Length declared | 176.8 in · 4,490 mm | 179.4 in · 4,556 mm | — |
| Width declared | 90.5 in · 2,299 mm | 97.2 in · 2,470 mm | +7% AgroStar 6.21 |
| Ground clearance declared | 24.4 in · 620 mm | 20.9 in · 530 mm | +17% 7110 |
| Fuel tank declared | 123.6 qt · 117.0 L | 179.6 qt · 170 L | +45% AgroStar 6.21 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 7110 sources
- Source: Traktorenlexikon, “Deutz-Allis 7110”
Deutz-Fahr AgroStar 6.21 sources
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 6.21”
- Source: Traktorenlexikon, “Deutz-Fahr DX 120”