8 material differences · fewer than 12
Tractor oneAGCO-ALLIS 87851998–1999No measured PTO figureTractor twoDEUTZ-ALLIS 71101986–1989No measured PTO figure
Which should you choose?
Read our verdict on the 8785 and the 7110 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 8785 | 7110 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 110.5 hp | 110.5 hp | — |
| Engine declared | SISU-DIESEL 666 T | — | — |
| Displacement declared | 6.59 L | — | — |
| Maximum torque declared | — | 281 lb·ft · 381 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Oil-cooled wet multi-disc clutch | Independent dry double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 28.8 gpm · 109.0 L/min | 24.0 gpm · 90.8 L/min | +20% 8785 |
| Pressure declared | 3,046 psi · 210 bar | 3,481 psi · 240 bar | +14% 7110 |
| Three-point lift, at the coupling points declared | 9,414 lb · 4,270 kg | 11,464 lb · 5,200 kg | +22% 7110 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,840 lb · 4,917 kg | 9,700 lb · 4,400 kg | +12% 8785 |
| Wheelbase declared | 112.6 in · 2,860 mm | 105.8 in · 2,687 mm | +6% 8785 |
| Length declared | 176.0 in · 4,470 mm | 176.8 in · 4,490 mm | — |
| Width declared | 88.0 in · 2,235 mm | 90.5 in · 2,299 mm | — |
| Ground clearance declared | — | 24.4 in · 620 mm | — |
| Fuel tank declared | 237.8 qt · 225.0 L | 123.6 qt · 117.0 L | +92% 8785 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 8785 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 8785”
DEUTZ-ALLIS 7110 sources
Source
- Source: Traktorenlexikon, “Deutz-Allis 7110”