• Rigid chassis
  • WhichTractor size: Standard-size
  • Not independently tested
  • 1952–1955

WhichTractor size, not the maker’s category

Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is

SOMECA DA-50 Full specifications

O.M.-MILANO COD-40 four-cylinder diesel. The manufacturer claimed 40.5 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.

Engine power, claimed · gross or net not stated

40.5 hp

30.2 kW as stated by the source

Not independently tested

Claimed · standard not stated by the source

Source · Traktorenlexikon, “Someca DA 50”, claimed

Weight
4,586 lb
3-point lift
1,764 lb
Hyd. flow
2.4 gpm
Top speed
13.7 mph

SOMECA DA-50 specs: key facts

  • The SOMECA DA-50 was built from 1952 to 1955.

  • The SOMECA DA-50 has a claimed engine power (gross or net not stated) of 30.2 kW (40.5 hp); it has no measured PTO figure.

  • The SOMECA DA-50 is two-wheel drive (2WD).

  • The SOMECA DA-50 has a O.M.-MILANO COD-40 engine, a 4-cylinder 3.77 L diesel unit.

  • The SOMECA DA-50 weighs 2,080 kg (4,586 lb) unladen.

  • The SOMECA DA-50 has a dependent rear PTO running at 540 rpm.

  • The three-point hitch of the SOMECA DA-50 lifts 800 kg (1,764 lb) at the lower-link ends.

  • The hydraulic pump of the SOMECA DA-50 delivers 9.2 L/min (2.4 gpm).

Source · Traktorenlexikon, “Someca DA 50”

How much horsepower does a DA-50 have?

The only figure for the DA-50 is 40.5 hp (30.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.

Engine, claimed (gross/net not stated)
40.5 hp

Source · Traktorenlexikon, “Someca DA 50”

What engine is in a DA-50?

A DA-50 has an O.M.-MILANO COD-40, a 4-cylinder 3.77 L diesel engine.

Engine — DA-50 engine specifications
Make & modelO.M.-MILANO COD-40
Cylinders4, liquid-cooled
Displacement230.1 ci · 3.77 L
Max torque137 lb·ft · 186 N·m @ 1,100 rpm
Electrical system12 V

Source · Traktorenlexikon, “Someca DA 50”

How much will a DA-50 lift, and what is its hydraulic flow?

A DA-50 lifts 1,764 lb (800 kg) at the lower-link ends of its Category 1 three-point hitch.

Hydraulics & PTO — DA-50 hydraulics and PTO specifications
Pump flow2.4 gpm · 9.2 L/min
Hitch categoryCategory 1
Lift at ends1,764 lb · 800 kg
Rear PTODependent, transmission-driven, 540 rpm

Source · Traktorenlexikon, “Someca DA 50”

What transmission does a DA-50 have?

Transmission specifications for the DA-50 are below.

Transmission — DA-50 transmission specifications
SteeringMechanically operated GEMMER steering, type: 60 M
Top speed13.7 mph · 22 km/h

Source · Traktorenlexikon, “Someca DA 50”

How much does a DA-50 weigh?

A DA-50 weighs 4,586 lb (2,080 kg) unladen.

Weights & dimensions — DA-50 weights and dimensions
Unladen weight4,586 lb · 2,080 kg
Wheelbase75.0 in · 1,905 mm
Length116.5 in · 2,960 mm
Width70.1 in · 1,780 mm
Height73.2 in · 1,860 mm
Ground clearance15.7 in · 400 mm
Front track51.2 in · 1,300 mm
Rear track57.1–75.6 in · 1,450–1,920 mm

Source · Traktorenlexikon, “Someca DA 50”

Which tractors compare with a DA-50?

Within 10% of its 39.0 hp at the PTO (claimed), the same type, and first built within 15 years of it.

Everything else people ask

Is a DA-50 two-wheel drive or four-wheel drive?

The SOMECA DA-50 is two-wheel drive (2WD).

What PTO does a DA-50 have?

A DA-50 has a dependent 540 rpm rear PTO.

Where this page comes from

Compiled from Traktorenlexikon, “Someca DA 50”.

Last verified

Not yet verified

Spotted an error?

Sources

Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution

  1. Traktorenlexikon: Someca DA 50CC BY-SA 4.0, WIKIBOOKS-TL-121053 · revision 1061245. Wikibooks contributors (Traktorenlexikon). Original document