- Rigid chassis
- WhichTractor size: High-power
- Not independently tested
- 1959–1969
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
J.I. Case 941 GP Full specifications
The manufacturer claimed 83.0 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
83.0 hp
61.9 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Case 941”, claimed
- Weight
- 8,805 lb
- Hyd. flow
- 15.5 gpm
- Top speed
- 15.5 mph
J.I. Case 941 GP specs: key facts
The J.I. Case 941 GP was built from 1959 to 1969.
The J.I. Case 941 GP has a claimed engine power (gross or net not stated) of 61.9 kW (83.0 hp); it has no measured PTO figure.
The J.I. Case 941 GP is two-wheel drive (2WD).
The J.I. Case 941 GP weighs 3,994 kg (8,805 lb) unladen.
The J.I. Case 941 GP has a rear PTO running at 540/1000 rpm.
The hydraulic pump of the J.I. Case 941 GP delivers 58.7 L/min (15.5 gpm).
Source · Traktorenlexikon, “Case 941”
How much horsepower does a 941 GP have?
The only figure for the 941 GP is 83.0 hp (61.9 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Case 941”
How much will a 941 GP lift, and what is its hydraulic flow?
Hydraulic and PTO specifications for the 941 GP are below.
| Pump flow | 15.5 gpm · 58.7 L/min |
|---|---|
| Hitch category | Category 1 |
| Rear PTO | 540/1000 rpm @ 1,682 engine rpm |
Source · Traktorenlexikon, “Case 941”
What transmission does a 941 GP have?
Transmission specifications for the 941 GP are below.
| Clutch | Pedal-operated dry CASE single-plate clutch |
|---|---|
| Steering | Mechanical steering with ball joint suspension including hydraulic power assist |
| Top speed | 15.5 mph · 25 km/h |
Source · Traktorenlexikon, “Case 941”
How much does a 941 GP weigh?
A 941 GP weighs 8,805 lb (3,994 kg) unladen.
| Unladen weight | 8,805 lb · 3,994 kgLPG: 4,071 |
|---|---|
| Wheelbase | 108.0 in · 2,743 mm |
| Length | 162.0 in · 4,115 mm |
| Width | 85.2 in · 2,165 mm |
| Height | 66.0 in · 1,676 mm |
| Ground clearance | 17.0 in · 432 mm |
| Front track | 53.7–83.4 in · 1,365–2,118 mm |
| Rear track | 64.0–96.0 in · 1,626–2,438 mm |
| Turning radius, braked | 10.8 ft · 3.30 m |
Source · Traktorenlexikon, “Case 941”
Which tractors compare with a 941 GP?
Within 10% of its 83.0 hp of claimed engine power, the same type, and first built within 15 years of it.
- J.I. Case 94083.0 hp engine, claimed · 1962–1969Side by side with the 941 GP →
- Fiat 80-R82.9 hp engine, claimed · 1961–1967Side by side with the 941 GP →
- Deutz D 900583.4 hp engine, claimed · 1967Side by side with the 941 GP →
- Fendt Favorit 610 S83.4 hp engine, claimed · 1972–1976Side by side with the 941 GP →
- Renault 9681.0 hp engine, claimed · 1969–1972Side by side with the 941 GP →
- SAME 480 (DT)80.9 hp engine, claimed · 1959–1962Side by side with the 941 GP →
Everything else people ask
Is a 941 GP two-wheel drive or four-wheel drive?
The J.I. Case 941 GP is two-wheel drive (2WD).
What PTO does a 941 GP have?
A 941 GP has a 540/1000 rpm rear PTO.
Where this page comes from
Compiled from Traktorenlexikon, “Case 941”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Case 941 — CC BY-SA 4.0, WIKIBOOKS-TL-115325 · revision 989857. Wikibooks contributors (Traktorenlexikon). Original document