- WhichTractor size: Compact
- Not independently tested
- 1983–1991
WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Ford 2910 Full specifications
The manufacturer claimed 40.5 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
40.5 hp
30.2 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Ford 2910”, claimed
- Weight
- 4,850 lb
- Hyd. flow
- 7.7 gpm
- Top speed
- 18.6 mph
Ford 2910 specs: key facts
The Ford 2910 was built from 1983 to 1991.
The Ford 2910 has a claimed engine power (gross or net not stated) of 30.2 kW (40.5 hp); it has no measured PTO figure.
The Ford 2910 is two-wheel drive (2WD).
The Ford 2910 weighs 2,200 kg (4,850 lb) unladen.
The Ford 2910 has an independent rear PTO running at 540 rpm.
The hydraulic pump of the Ford 2910 delivers 29.0 L/min (7.7 gpm).
Source · Traktorenlexikon, “Ford 2910”
How much horsepower does a 2910 have?
The only figure for the 2910 is 40.5 hp (30.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Ford 2910”
How much will a 2910 lift, and what is its hydraulic flow?
Hydraulic and PTO specifications for the 2910 are below.
| Pump flow | 7.7 gpm · 29.0 L/min |
|---|---|
| Pressure | 2,553 psi · 176 bar |
| Hitch category | Category 1 |
| Rear PTO | Independent, engine-driven, 540 rpm @ 1,800 engine rpmEngages under load |
Source · Traktorenlexikon, “Ford 2910”
What transmission does a 2910 have?
Transmission specifications for the 2910 are below.
| Brakes | Oil bath disc brake in rear axle |
|---|---|
| Steering | Recirculating ball steering with hydraulic power assist |
| Top speed | 18.6 mph · 30.0 km/h |
Source · Traktorenlexikon, “Ford 2910”
How much does a 2910 weigh?
A 2910 weighs 4,850 lb (2,200 kg) unladen.
| Unladen weight | 4,850 lb · 2,200 kg |
|---|---|
| Wheelbase | 77.5 in · 1,969 mm |
| Length | 134.6 in · 3,418 mm |
| Width | 68.4 in · 1,737 mm |
| Height | 89.5 in · 2,274 mm |
| Ground clearance | 12.5 in · 317 mm |
| Front track | 52.4–80.4 in · 1,332–2,043 mm |
| Rear track | 56.0–80.0 in · 1,422–2,032 mm |
Source · Traktorenlexikon, “Ford 2910”
Which tractors compare with a 2910?
Within 10% of its 36.1 hp at the PTO (claimed), the same type, and first built within 15 years of it.
- Ford 261036.1 hp PTO, claimed · 1981–1983Side by side with the 2910 →
- Hürlimann H-345 (A)36.2 hp PTO, claimed · 1982–1986Side by side with the 2910 →
- John Deere 93035.9 hp PTO, claimed · 1974–1977Side by side with the 2910 →
- UZINA TRACTORUL R-450 (DT)36.3 hp PTO, claimed · 1974–1981Side by side with the 2910 →
- Fiat 450/N (DT)36.3 hp PTO, claimed · 1970–1977Side by side with the 2910 →
- SOMECA 450-N (DT)36.3 hp PTO, claimed · 1970–1977Side by side with the 2910 →
Everything else people ask
Is a 2910 two-wheel drive or four-wheel drive?
The Ford 2910 is two-wheel drive (2WD).
What PTO does a 2910 have?
A 2910 has a independent 540 rpm rear PTO.
Where this page comes from
Compiled from Traktorenlexikon, “Ford 2910”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Ford 2910 — CC BY-SA 4.0, WIKIBOOKS-TL-90988 · revision 689333. Wikibooks contributors (Traktorenlexikon). Original document