9 material differences · fewer than 12
Tractor oneFiat 450/N (DT)1970–1977No measured PTO figureTractor twoFord 29101983–1991No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (29%); the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1970–1977; 1983–1991). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 450/N (DT) | 2910 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 42.4 hp | 40.5 hp | — |
| Engine declared | FIAT-IVECO 8035.01.300 | — | — |
| Displacement declared | 2.34 L | — | — |
| Maximum torque declared | 103 lb·ft · 140 N·m | 122 lb·ft · 165 N·m | +18% 2910 |
| Transmission | |||
| Top speed declared | 16.8 mph · 27 km/h | 18.6 mph · 30.0 km/h | +11% 2910 |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | 7.7 gpm · 29.0 L/min | +33% 2910 |
| Pressure declared | 2,843 psi · 196 bar | 2,553 psi · 176 bar | +11% 450/N (DT) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,748 lb · 1,700 kg | 4,850 lb · 2,200 kg | +29% 2910 |
| Wheelbase declared | 75.6 in · 1,920 mm | 77.5 in · 1,969 mm | — |
| Length declared | 126.0 in · 3,200 mm | 134.6 in · 3,418 mm | +7% 2910 |
| Width declared | 62.4–88.2 in · 1,585–2,240 mm | 68.4 in · 1,737 mm | differs |
| Ground clearance declared | 14.6 in · 370 mm | 12.5 in · 317 mm | +17% 450/N (DT) |
| Turning radius, braked declared | 9.7 ft · 2.95 m | — | — |
| Fuel tank declared | 57.1 qt · 54.0 L | 52.1 qt · 49.3 L | +10% 450/N (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 450/N (DT) sources
- Source: Traktorenlexikon, “Fiat 450-N/450-N DT”
- Source: Traktorenlexikon, “Someca 450 N”
Ford 2910 sources
- Source: Traktorenlexikon, “Ford 2910”