- Rigid chassis
- WhichTractor size: Utility
- No lab test on file
- 1982–1983
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Deutz-Fahr DX 80 specs: hp, weight, years
KHD F4L 913 four-cylinder diesel. The manufacturer claimed 74 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
74 hp
55 kW as stated by the source
No lab test on file
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Deutz-Fahr DX 80”, claimed
This is the maker’s own figure, measured at the engine. Power at the PTO is lower — by how much, for this machine, nobody has measured.
- Weight
- 7,937 lb
- 3-point lift
- 8,378 lb
- Top speed
- 18.6–24.9 mph
Deutz-Fahr DX 80 specs: key facts
The Deutz-Fahr DX 80 was built from 1982 to 1983.
The Deutz-Fahr DX 80 has a claimed engine power (gross or net not stated) of 55 kW (74 hp); it has no measured PTO figure.
The Deutz-Fahr DX 80 was offered in two-wheel-drive and four-wheel-drive versions.
The Deutz-Fahr DX 80 has a KHD F4L 913 engine, a 4-cylinder 4.09 L diesel unit.Source 1
The Deutz-Fahr DX 80 weighs 3,600 kg (7,937 lb) unladen.
The Deutz-Fahr DX 80 has a rear PTO running at 540 rpm / 1000 rpm.
The three-point hitch of the Deutz-Fahr DX 80 lifts 3,800 kg (8,378 lb) at the lower-link ends.
Source · Traktorenlexikon, “Deutz-Fahr DX 80”
How much horsepower does a DX 80 have?
The only figure for the DX 80 is 74 hp (55 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Deutz-Fahr DX 80”
What engine is in a DX 80?
A DX 80 has a KHD F4L 913, a 4-cylinder 4.09 L diesel engine.
| Make & model | KHD F4L 913 |
|---|---|
| Cylinders | 4, air-cooledSource 2 |
| Displacement | 249.3 ci · 4.09 L |
| Max torque | 196 lb·ft · 266 N·mSource 2 |
| Electrical system | 12 VSource 2 |
Source · Traktorenlexikon, “Deutz-Fahr DX 3.90”
How much will a DX 80 lift?
A DX 80 lifts 8,378 lb (3,800 kg) at the lower-link ends.
| System | Open centre |
|---|---|
| Pressure | 1,740 psi · 120 bar |
| Lift at ends | 8,378 lb · 3,800 kg |
| Rear PTO | 540 rpm / 1000 rpm |
Source · Traktorenlexikon, “Deutz-Fahr DX 80”
What transmission does a DX 80 have?
Transmission specifications for the DX 80 are below.
| Steering | Hydrostatic ZF or DANFOSS steering |
|---|---|
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
Source · Traktorenlexikon, “Deutz-Fahr DX 80”
How much does a DX 80 weigh?
A DX 80 weighs 7,937 lb (3,600 kg) unladen.
| Unladen weight | 7,937 lb · 3,600 kgtwo-wheel-drive version |
|---|---|
| Maximum front axle load | 3,858 lb · 1,750 kg |
| Maximum rear axle load | 9,259 lb · 4,200 kg |
| Wheelbase | 91.7 in · 2,330 mmtwo-wheel-drive version |
| Length | 159.1 in · 4,040 mmtwo-wheel-drive version |
| Width | 90.6 in · 2,300 mm |
| Height | 102.8 in · 2,610 mm |
| Ground clearance | 23.2 in · 590 mmtwo-wheel-drive version |
| Front track | 63.0–78.7 in · 1,600–2,000 mmtwo-wheel-drive version |
| Rear track | 64.6 in · 1,640 mm |
Source · Traktorenlexikon, “Deutz-Fahr DX 80”
What oil does a DX 80 take, and how much?
A DX 80 engine takes 11.6 qt (11 L). Single source, not independently verified — always confirm against the operator’s manual for your machine.
| System | Capacity |
|---|---|
| Engine oil | 11.6 qt · 11 LSource: Traktorenlexikon, “Deutz-Fahr DX 80” · single source, not independently verified |
| Transmission | 22.7 qt · 21.5 LSource: Traktorenlexikon, “Deutz-Fahr DX 80” · single source, not independently verified |
Always confirm against the operator’s manual for your machine before service.
Which tractors compare with a DX 80?
Within 10% of its 74 hp of claimed engine power, the same type, and first built within 15 years of it.
- Deutz-Fahr DX 3.9074 hp engine, claimed · 1984–1989Side by side with the DX 80 →
- Massey Ferguson 294 AS74 hp engine, claimed · 1980–1987Side by side with the DX 80 →
- Deutz-Fahr DX 3.80 AS74 hp engine, claimed · 1985–1990Side by side with the DX 80 →
- Fendt Farmer 108 LS/LSA74 hp engine, claimed · 1977–1980Side by side with the DX 80 →
- Fendt Farmer 30774 hp engine, claimed · 1993–1998Side by side with the DX 80 →
- Massey Ferguson 3055 (A)74 hp engine, claimed · 1993–1995Side by side with the DX 80 →
Common questions about the Deutz-Fahr DX 80
Is a DX 80 two-wheel drive or four-wheel drive?
The Deutz-Fahr DX 80 was offered in two-wheel-drive and four-wheel-drive versions.
What PTO does a DX 80 have?
A DX 80 has a 540 rpm / 1000 rpm rear PTO.
Sources and how this page was built
Compiled from Traktorenlexikon, “Deutz-Fahr DX 3.90”; and Traktorenlexikon, “Deutz-Fahr DX 80”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Deutz-Fahr DX 3.90 — CC BY-SA 4.0, WIKIBOOKS-TL-32890 · revision 1059337. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: Deutz-Fahr DX 80 — CC BY-SA 4.0, WIKIBOOKS-TL-74800 · revision 1089911. Wikibooks contributors (Traktorenlexikon). Original document