- Rigid chassis
- WhichTractor size: Utility
- Not independently tested
- 1993–1996
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Deutz-Fahr DX 3.75 A Full specifications
KHD F4L 913 four-cylinder diesel. The manufacturer claimed 76.6 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
76.6 hp
57.1 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”, claimed
- Weight
- 7,077 lb
- 3-point lift
- 7,275 lb
- Hyd. flow
- 10.6 gpm
- Top speed
- 18.6–24.9 mph
Deutz-Fahr DX 3.75 A specs: key facts
The Deutz-Fahr DX 3.75 A was built from 1993 to 1996.
The Deutz-Fahr DX 3.75 A has a claimed engine power (gross or net not stated) of 57.1 kW (76.6 hp); it has no measured PTO figure.
The Deutz-Fahr DX 3.75 A is four-wheel drive (4WD).
The Deutz-Fahr DX 3.75 A has a KHD F4L 913 engine, a 4-cylinder 4.09 L diesel unit.Source 2
The Deutz-Fahr DX 3.75 A weighs 3,210 kg (7,077 lb) unladen.
The Deutz-Fahr DX 3.75 A has an independent rear PTO running at 540/1000 rpm.
The three-point hitch of the Deutz-Fahr DX 3.75 A lifts 3,300 kg (7,275 lb) at the lower-link ends.
The hydraulic pump of the Deutz-Fahr DX 3.75 A delivers 40.0 L/min (10.6 gpm).
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
How much horsepower does a DX 3.75 A have?
The only figure for the DX 3.75 A is 76.6 hp (57.1 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
What engine is in a DX 3.75 A?
A DX 3.75 A has a KHD F4L 913, a 4-cylinder 4.09 L diesel engine.
| Make & model | KHD F4L 913Source 2 |
|---|---|
| Cylinders | 4, air-cooledSource 2 |
| Displacement | 249.3 ci · 4.09 LSource 2 |
| Max torque | 183 lb·ft · 248 N·m @ 1,500 rpm |
| Injection | Direct injection |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
How much will a DX 3.75 A lift, and what is its hydraulic flow?
A DX 3.75 A lifts 7,275 lb (3,300 kg) at the lower-link ends of its Category 2 three-point hitch.
| System | Open centre |
|---|---|
| Pump flow | 10.6 gpm · 40.0 L/min |
| Pressure | 3,481 psi · 240 bar |
| Hitch category | Category 2 |
| Lift at ends | 7,275 lb · 3,300 kg |
| Rear PTO | Independent, 540/1000 rpm @ 2,202 engine rpmEngages under load |
| PTO shaft | 1 3/8"- 6 splines |
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
What transmission does a DX 3.75 A have?
Transmission specifications for the DX 3.75 A are below.
| Clutch | Independent dry double clutch |
|---|---|
| Steering | Hydrostatic Danfoss steering |
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
How much does a DX 3.75 A weigh?
A DX 3.75 A weighs 7,077 lb (3,210 kg) unladen.
| Unladen weight | 7,077 lb · 3,210 kg |
|---|---|
| Maximum permissible mass | 11,023 lb · 5,000 kg |
| Maximum front axle load | 4,630 lb · 2,100 kg |
| Maximum rear axle load | 7,716 lb · 3,500 kg |
| Wheelbase | 88.6 in · 2,250 mm |
| Length | 141.7 in · 3,600 mm |
| Width | 84.2 in · 2,138 mm |
| Height | 92.2 in · 2,341 mm |
| Ground clearance | 16.1 in · 408 mm |
| Front track | 59.1–65.0 in · 1,500–1,650 mmthe article lists alternatives |
| Rear track | 59.1–63.0 in · 1,500–1,600 mm |
| Turning radius, braked | 12.8 ft · 3.90 m |
Source · Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
Which tractors compare with a DX 3.75 A?
Within 10% of its 76.6 hp of claimed engine power, the same type, and first built within 15 years of it.
- Case-IH CS-78 (A)77.0 hp engine, claimed · 1995–2003Side by side with the DX 3.75 A →
- Renault 85-32 MX77.0 hp engine, claimed · 1989–1993Side by side with the DX 3.75 A →
- Renault 80-12 TX77.0 hp engine, claimed · 1985–1987Side by side with the DX 3.75 A →
- Renault 85-12 LS77.0 hp engine, claimed · 1985–1989Side by side with the DX 3.75 A →
- Agco LT-7577.0 hp engine, claimed · 2004–2006Side by side with the DX 3.75 A →
- AGRIFULL 80-75 (DT)77.0 hp engine, claimed · 1980–1986Side by side with the DX 3.75 A →
Everything else people ask
Is a DX 3.75 A two-wheel drive or four-wheel drive?
The Deutz-Fahr DX 3.75 A is four-wheel drive (4WD).
What PTO does a DX 3.75 A have?
A DX 3.75 A has a independent 540/1000 rpm rear PTO on a 1 3/8"- 6 splines shaft.
Where this page comes from
Compiled from Traktorenlexikon, “Deutz-Fahr DX 3.75 A”; and Traktorenlexikon, “Deutz-Fahr DX 3.90”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Deutz-Fahr DX 3.75 A — CC BY-SA 4.0, WIKIBOOKS-TL-102983 · revision 823389. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: Deutz-Fahr DX 3.90 — CC BY-SA 4.0, WIKIBOOKS-TL-32890 · revision 1059337. Wikibooks contributors (Traktorenlexikon). Original document