10 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 3.75 A1993–1996No measured PTO figureTractor twoRenault 85-12 TX1986–1989No measured PTO figure
Which should you choose?
Read our verdict on the DX 3.75 A and the 85-12 TX → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | DX 3.75 A | 85-12 TX | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 76.6 hp | 77.0 hp | — |
| Engine declared | KHD F4L 913 | MWM D 226-4 | differs |
| Displacement declared | 4.09 L | 4.15 L | — |
| Maximum torque declared | 183 lb·ft · 248 N·m | 181 lb·ft · 245 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Independent dry double clutch | Dry LuK double clutch type 310/310 G | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | 10.9 gpm · 41.4 L/min | — |
| Pressure declared | 3,481 psi · 240 bar | 1,595 psi · 110 bar | +118% DX 3.75 A |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,077 lb · 3,210 kg | 7,507 lb · 3,405 kg | +6% 85-12 TX |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | — | — |
| Wheelbase declared | 88.6 in · 2,250 mm | 95.6 in · 2,428 mm | +8% 85-12 TX |
| Length declared | 141.7 in · 3,600 mm | 154.9 in · 3,934 mm | +9% 85-12 TX |
| Width declared | 84.2 in · 2,138 mm | 78.0–87.8 in · 1,980–2,229 mm | differs |
| Ground clearance declared | 16.1 in · 408 mm | 14.8 in · 377 mm | +8% DX 3.75 A |
| Turning radius, braked declared | 12.8 ft · 3.90 m | 12.8 ft · 3.90 m | — |
| Fuel tank declared | 91.9 qt · 87 L | 108.8 qt · 103.0 L | +18% 85-12 TX |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 3.75 A sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.90”
Renault 85-12 TX sources
- Source: Traktorenlexikon, “Renault 85-12 TS/TX R7761”
- Source: Traktorenlexikon, “Fendt Farmer 108 S/SA”