- Rigid chassis
- WhichTractor size: Standard-size
- Not independently tested
- 1991–1996
It sits on the utility/standard-size boundary, so either size is a fair description. It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
AGCO-ALLIS 7600 Full specifications
S.L.H. 1055 P five-cylinder diesel. The manufacturer claimed 95.6 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
95.6 hp
71.3 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “AGCO-Allis 7600”, claimed
- Weight
- 8,598 lb
- 3-point lift
- 10,141 lb
- Hyd. flow
- 16.9 gpm
- Top speed
- 18.6 mph
AGCO-ALLIS 7600 specs: key facts
The AGCO-ALLIS 7600 was built from 1991 to 1996.
The AGCO-ALLIS 7600 has a claimed engine power (gross or net not stated) of 71.3 kW (95.6 hp); it has no measured PTO figure.
The AGCO-ALLIS 7600 was offered in two-wheel-drive and four-wheel-drive versions.
The AGCO-ALLIS 7600 has a S.L.H. 1055 P engine, a 5-cylinder 5.19 L diesel unit.
The AGCO-ALLIS 7600 weighs 3,900 kg (8,598 lb) unladen.
The AGCO-ALLIS 7600 has an independent rear PTO running at 540/1000 rpm.
The three-point hitch of the AGCO-ALLIS 7600 lifts 4,600 kg (10,141 lb) at the lower-link ends.
The hydraulic pump of the AGCO-ALLIS 7600 delivers 64.0 L/min (16.9 gpm).
Source · Traktorenlexikon, “AGCO-Allis 7600”
How much horsepower does a 7600 have?
The only figure for the 7600 is 95.6 hp (71.3 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “AGCO-Allis 7600”
What engine is in a 7600?
A 7600 has a S.L.H. 1055 P, a 5-cylinder 5.19 L diesel engine.
| Make & model | S.L.H. 1055 P |
|---|---|
| Cylinders | 5, air-cooled |
| Displacement | 316.9 ci · 5.19 L |
| Max torque | 242 lb·ft · 328 N·m @ 1,424 rpm |
| Injection | direct injection |
| Electrical system | 12 V |
Source · Traktorenlexikon, “AGCO-Allis 7600”
How much will a 7600 lift, and what is its hydraulic flow?
A 7600 lifts 10,141 lb (4,600 kg) at the lower-link ends of its Category 2 three-point hitch.
| System | Open centre |
|---|---|
| Pump flow | 16.9 gpm · 64.0 L/min |
| Pressure | 1,740 psi · 120 bar |
| Hitch category | Category 2 |
| Lift at ends | 10,141 lb · 4,600 kg |
| Rear PTO | Independent, engine-driven, 540/1000 rpm @ 1,958 engine rpmEngages under load |
| PTO shaft | 1 3/8"- 6 splines and 1 3/8"- 21 part |
Source · Traktorenlexikon, “AGCO-Allis 7600”
What transmission does a 7600 have?
Transmission specifications for the 7600 are below.
| Clutch | pedal operated dry SLH double clutch |
|---|---|
| Brakes | pedal operated wet SLH disc brake acting on differential side shafts |
| Steering | hydrostatic ZF steering type SERVOSTAT-8494 with two single-acting steering cylinders |
| Top speed | 18.6 mph · 30 km/h |
Source · Traktorenlexikon, “AGCO-Allis 7600”
How much does a 7600 weigh?
A 7600 weighs 8,598 lb (3,900 kg) unladen.
| Unladen weight | 8,598 lb · 3,900 kg4 WD: 4,440 |
|---|---|
| Maximum permissible mass | 11,464 lb · 5,200 kg |
| Maximum front axle load | 3,968 lb · 1,800 kg |
| Maximum rear axle load | 8,818 lb · 4,000 kg |
| Wheelbase | 104.6 in · 2,657 mm4 WD: 2,642 |
| Length | 168.2 in · 4,272 mm |
| Width | 84.0 in · 2,134 mm |
| Height | 110.0 in · 2,794 mm |
| Ground clearance | 17.6 in · 447 mm4 WD: 467 |
| Front track | 60.0–80.0 in · 1,524–2,032 mm4 WD: 1,626-1,930 |
| Rear track | 61.0–85.2 in · 1,549–2,164 mm |
| Turning radius, braked | 11.0 ft · 3.35 m4 WD: 3,350 |
Source · Traktorenlexikon, “AGCO-Allis 7600”
Which tractors compare with a 7600?
Within 10% of its 95.6 hp of claimed engine power, the same type, and first built within 15 years of it.
- J.I. Case 1594 (DT)95.6 hp engine, claimed · 1984–1985Side by side with the 7600 →
- Agco RT-9595.6 hp engine, claimed · 2002–2004Side by side with the 7600 →
- Deutz-Fahr Agrotron 4.9594.9 hp engine, claimed · 1995–1997Side by side with the 7600 →
- Deutz-Fahr Agrotron 6.0094.9 hp engine, claimed · 1995–1997Side by side with the 7600 →
- URSUS 113497 hp engine, claimed · 1990–2009Side by side with the 7600 →
- AGCO-ALLIS 877594.7 hp engine, claimed · 1998–1999Side by side with the 7600 →
Everything else people ask
Is a 7600 two-wheel drive or four-wheel drive?
The AGCO-ALLIS 7600 was offered in two-wheel-drive and four-wheel-drive versions.
What PTO does a 7600 have?
A 7600 has a independent 540/1000 rpm rear PTO on a 1 3/8"- 6 splines and 1 3/8"- 21 part shaft.
Where this page comes from
Compiled from Traktorenlexikon, “AGCO-Allis 7600”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: AGCO-Allis 7600 — CC BY-SA 4.0, WIKIBOOKS-TL-122654 · revision 1085986. Wikibooks contributors (Traktorenlexikon). Original document