- Rigid chassis
- WhichTractor size: Utility
- Not independently tested
- 1992–1997
WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
VALMET 565/II Full specifications
VALMET 320 DS three-cylinder diesel. The manufacturer claimed 74.0 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
74.0 hp
55.2 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Valmet 565/II”, claimed
- Weight
- 6,834 lb
- 3-point lift
- 5,688 lb
- Hyd. flow
- 14.5 gpm
- Top speed
- 18.6–24.9 mph
VALMET 565/II specs: key facts
The VALMET 565/II was built from 1992 to 1997.
The VALMET 565/II has a claimed engine power (gross or net not stated) of 55.2 kW (74.0 hp); it has no measured PTO figure.
The VALMET 565/II is four-wheel drive (4WD).
The VALMET 565/II has a VALMET 320 DS engine, a 3-cylinder 3.30 L diesel unit.Source 1
The VALMET 565/II weighs 3,100 kg (6,834 lb) unladen.
The VALMET 565/II has an independent rear PTO running at 540E/540 rpm.
The three-point hitch of the VALMET 565/II lifts 2,580 kg (5,688 lb) at the lower-link ends.
The hydraulic pump of the VALMET 565/II delivers 55.0 L/min (14.5 gpm).
Source · Traktorenlexikon, “Valmet 565/II”
How much horsepower does a 565/II have?
The only figure for the 565/II is 74.0 hp (55.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Valmet 565/II”
What engine is in a 565/II?
A 565/II has a VALMET 320 DS, a 3-cylinder 3.30 L diesel engine.
| Make & model | VALMET 320 DSSource 1 |
|---|---|
| Cylinders | 3, liquid-cooledSource 1 |
| Displacement | 201.3 ci · 3.30 LSource 1 |
| Max torque | 203 lb·ft · 275 N·m @ 1,450 rpm |
| Injection | Direct injection |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Valmet 565/II”
How much will a 565/II lift, and what is its hydraulic flow?
A 565/II lifts 5,688 lb (2,580 kg) at the lower-link ends of its Category 2 three-point hitch.
| System | Open centre |
|---|---|
| Pump flow | 14.5 gpm · 55.0 L/min |
| Pressure | 2,901 psi · 200 bar |
| Hitch category | Category 2 |
| Lift at ends | 5,688 lb · 2,580 kg |
| Rear PTO | Independent, engine-driven, 540E/540 rpm @ 1,890 engine rpmEngages under load |
| PTO shaft | 1 3/8"- 6 splines and 1 3/8"- 21 part |
Source · Traktorenlexikon, “Valmet 565/II”
What transmission does a 565/II have?
Transmission specifications for the 565/II are below.
| Clutch | Dry LuK double clutch |
|---|---|
| Brakes | Pedal-operated wet GIRLING multi-disc brake acting on differential side shafts |
| Steering | Hydrostatic steering |
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
Source · Traktorenlexikon, “Valmet 565/II”
How much does a 565/II weigh?
A 565/II weighs 6,834 lb (3,100 kg) unladen.
| Unladen weight | 6,834 lb · 3,100 kg |
|---|---|
| Wheelbase | 88.8 in · 2,255 mm |
| Length | 152.4 in · 3,870 mm |
| Width | 79.9 in · 2,030 mm |
| Height | 104.5 in · 2,655 mm |
| Ground clearance | 18.1 in · 460 mm |
| Front track | 56.3–63.9 in · 1,430–1,624 mm |
| Rear track | 55.0–66.9 in · 1,398–1,700 mm |
| Turning radius, braked | 13.8 ft · 4.20 m |
Source · Traktorenlexikon, “Valmet 565/II”
Which tractors compare with a 565/II?
Within 10% of its 61.0 hp at the PTO (claimed), the same type, and first built within 15 years of it.
- SAME Dorado 70 (DT)61.0 hp PTO, claimed · 1995–2000Side by side with the 565/II →
- Landini 7800 (DT)61.0 hp PTO, claimed · 1987–2000Side by side with the 565/II →
- Massey Ferguson MF 3050 E61.0 hp PTO, claimed · 1988–1995Side by side with the 565/II →
- Fiat 70-66 (DT)60.9 hp PTO, claimed · 1984–1991Side by side with the 565/II →
- Fiat 70-66 F (DT/F)60.9 hp PTO, claimed · 1984–1991Side by side with the 565/II →
- International Harvester 785 (A)61.2 hp PTO, claimed · 1981–1990Side by side with the 565/II →
Everything else people ask
Is a 565/II two-wheel drive or four-wheel drive?
The VALMET 565/II is four-wheel drive (4WD).
What PTO does a 565/II have?
A 565/II has a independent 540E/540 rpm rear PTO on a 1 3/8"- 6 splines and 1 3/8"- 21 part shaft.
Where this page comes from
Compiled from Traktorenlexikon, “Valmet 465”; and Traktorenlexikon, “Valmet 565/II”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Valmet 465 — CC BY-SA 4.0, WIKIBOOKS-TL-116427 · revision 998452. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: Valmet 565/II — CC BY-SA 4.0, WIKIBOOKS-TL-116428 · revision 998453. Wikibooks contributors (Traktorenlexikon). Original document