12 material differences
Tractor oneDeutz-Fahr AgroCompact 3.90 F/S1992–1996No measured PTO figureTractor twoVALMET 565/II1992–1997No measured PTO figure
Which should you choose?
Read our verdict on the AgroCompact 3.90 F/S and the 565/II → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | AgroCompact 3.90 F/S | 565/II | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 74.0 hp | — |
| Engine declared | KHD F4L 913 | VALMET 320 DS | differs |
| Displacement declared | 4.09 L | 3.30 L | +24% AgroCompact 3.90 F/S |
| Maximum torque declared | 184 lb·ft · 250 N·m | 203 lb·ft · 275 N·m | +10% 565/II |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 10.8 gpm · 41.0 L/min | 14.5 gpm · 55.0 L/min | +34% 565/II |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Three-point lift, at the coupling points declared | 4,850 lb · 2,200 kg | 5,688 lb · 2,580 kg | +17% 565/II |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,960–5,622 lb · 2,250–2,550 kg | 6,834 lb · 3,100 kg | differs |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | — | — |
| Wheelbase declared | 80.5 in · 2,045 mm | 88.8 in · 2,255 mm | +10% 565/II |
| Length declared | 136.6 in · 3,470 mm | 152.4 in · 3,870 mm | +12% 565/II |
| Width declared | 47.2 in · 1,200 mm | 79.9 in · 2,030 mm | +69% 565/II |
| Ground clearance declared | 13.0 in · 330 mm | 18.1 in · 460 mm | +39% 565/II |
| Turning radius, braked declared | — | 13.8 ft · 4.20 m | — |
| Fuel tank declared | 58.1 qt · 55 L | 77.1 qt · 73.0 L | +33% 565/II |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr AgroCompact 3.90 F/S sources
- Source: Traktorenlexikon, “Deutz-Fahr AgroCompact 3.90”
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.90”
VALMET 565/II sources
- Source: Traktorenlexikon, “Valmet 565/II”
- Source: Traktorenlexikon, “Valmet 465”