- Vehicle type: unspecified
- Rigid chassis
- WhichTractor size: Utility
- Not independently tested
- 1960–1969
It sits on the utility/standard-size boundary, so either size is a fair description. WhichTractor size, not the maker’s category
We looked and the record does not say what this machine is. How we decide what a machine is
J.I. Case 730 Full specifications
The manufacturer claimed 57.9 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
57.9 hp
43.2 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Case 730”, claimed
- Weight
- 7,000 lb
- Hyd. flow
- 15.5 gpm
- Top speed
- 18.6 mph
J.I. Case 730 specs: key facts
The J.I. Case 730 was built from 1960 to 1969.
The J.I. Case 730 has a claimed engine power (gross or net not stated) of 43.2 kW (57.9 hp); it has no measured PTO figure.
The J.I. Case 730 is two-wheel drive (2WD).
The J.I. Case 730 weighs 3,175 kg (7,000 lb) unladen.
The J.I. Case 730 has an independent rear PTO running at 540/1000 rpm.
The hydraulic pump of the J.I. Case 730 delivers 58.7 L/min (15.5 gpm).
Source · Traktorenlexikon, “Case 730”
How much horsepower does a 730 have?
The only figure for the 730 is 57.9 hp (43.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Case 730”
How much will a 730 lift, and what is its hydraulic flow?
Hydraulic and PTO specifications for the 730 are below.
| Pump flow | 15.5 gpm · 58.7 L/min |
|---|---|
| Rear PTO | Independent, engine-driven, 540/1000 rpm |
Source · Traktorenlexikon, “Case 730”
What transmission does a 730 have?
Transmission specifications for the 730 are below.
| Top speed | 18.6 mph · 30 km/h |
|---|
Source · Traktorenlexikon, “Case 730”
How much does a 730 weigh?
A 730 weighs 7,000 lb (3,175 kg) unladen.
| Unladen weight | 7,000 lb · 3,175 kg |
|---|---|
| Wheelbase | 102.0 in · 2,591 mm |
| Length | 156.0 in · 3,962 mm |
| Width | 88.0 in · 2,235 mm |
| Height | 84.0 in · 2,134 mm |
| Ground clearance | 15.0 in · 381 mm |
| Front track | 52.0–58.0 in · 1,321–1,473 mm |
| Rear track | 52.0–64.0 in · 1,321–1,626 mm |
| Turning radius, braked | 7.1 ft · 2.16 m |
Source · Traktorenlexikon, “Case 730”
Which tractors compare with a 730?
Within 10% of its 55.7 hp at the PTO (claimed), the same type, and first built within 15 years of it.
- J.I. Case 73155.7 hp PTO, claimed · 1960–1969Side by side with the 730 →
- Leyland 27056.1 hp PTO, claimed · 1973–1975Side by side with the 730 →
- Lamborghini R-365 (DT)55.3 hp PTO, claimed · 1971–1973Side by side with the 730 →
- David Brown 1200 Selectmatic56.2 hp PTO, claimed · 1967–1971Side by side with the 730 →
- International Harvester 624 (A)55.2 hp PTO, claimed · 1965–1972Side by side with the 730 →
- Fiat 650-S (DT)55.2 hp PTO, claimed · 1971–1974Side by side with the 730 →
Everything else people ask
Is a 730 two-wheel drive or four-wheel drive?
The J.I. Case 730 is two-wheel drive (2WD).
What PTO does a 730 have?
A 730 has a independent 540/1000 rpm rear PTO.
Where this page comes from
Compiled from Traktorenlexikon, “Case 730”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Case 730 — CC BY-SA 4.0, WIKIBOOKS-TL-115318 · revision 989839. Wikibooks contributors (Traktorenlexikon). Original document