- Rigid chassis
- WhichTractor size: Standard-size
- Not independently tested
- 1966–1969
- 13,763 built
WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
J.I. Case 1031 Full specifications
The manufacturer claimed 102.1 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
102.1 hp
76.1 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Case 1031”, claimed
- Weight
- 9,334 lb
- Hyd. flow
- 12.0 gpm
- Top speed
- 15.5 mph
J.I. Case 1031 specs: key facts
The J.I. Case 1031 was built from 1966 to 1969.
The J.I. Case 1031 has a claimed engine power (gross or net not stated) of 76.1 kW (102.1 hp); it has no measured PTO figure.
The J.I. Case 1031 is two-wheel drive (2WD).
The J.I. Case 1031 weighs 4,234 kg (9,334 lb) unladen.
The J.I. Case 1031 has an independent rear PTO running at 1000 rpm.
The hydraulic pump of the J.I. Case 1031 delivers 45.4 L/min (12.0 gpm).
Source · Traktorenlexikon, “Case 1031”
How much horsepower does a 1031 have?
The only figure for the 1031 is 102.1 hp (76.1 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Case 1031”
How much will a 1031 lift, and what is its hydraulic flow?
Hydraulic and PTO specifications for the 1031 are below.
| Pump flow | 12.0 gpm · 45.4 L/min |
|---|---|
| Hitch category | Category 2 |
| Rear PTO | Independent, engine-driven, 1000 rpm |
Source · Traktorenlexikon, “Case 1031”
What transmission does a 1031 have?
Transmission specifications for the 1031 are below.
| Top speed | 15.5 mph · 25 km/h |
|---|
Source · Traktorenlexikon, “Case 1031”
How much does a 1031 weigh?
A 1031 weighs 9,334 lb (4,234 kg) unladen.
| Unladen weight | 9,334 lb · 4,234 kg |
|---|---|
| Wheelbase | 108.9 in · 2,767 mm |
| Length | 165.0 in · 4,191 mm |
| Width | 88.0 in · 2,235 mm |
| Height | 72.0 in · 1,829 mm |
| Ground clearance | 16.0 in · 406 mm |
| Front track | 56.0–81.0 in · 1,422–2,057 mm |
| Rear track | 76.0–92.0 in · 1,930–2,337 mm |
| Turning radius, braked | 11.2 ft · 3.43 m |
Source · Traktorenlexikon, “Case 1031”
Which tractors compare with a 1031?
Within 10% of its 93.1 hp at the PTO (claimed), the same type, and first built within 15 years of it.
- International Harvester 96693.5 hp PTO, claimed · 1971–1974Side by side with the 1031 →
- SAME Buffalo DT94 hp PTO, claimed · 1968–1974Side by side with the 1031 →
- Ford 800094.4 hp PTO, claimed · 1968–1972Side by side with the 1031 →
- SOMECA 980 (TD)91.1 hp PTO, claimed · 1979–1983Side by side with the 1031 →
- Fiat 1000 Super (DT)91 hp PTO, claimed · 1976–1979Side by side with the 1031 →
- Fiat 1000 Super (TD)90.7 hp PTO, claimed · 1976–1979Side by side with the 1031 →
Everything else people ask
Is a 1031 two-wheel drive or four-wheel drive?
The J.I. Case 1031 is two-wheel drive (2WD).
What PTO does a 1031 have?
A 1031 has a independent 1000 rpm rear PTO.
Where this page comes from
Compiled from Traktorenlexikon, “Case 1031”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Case 1031 — CC BY-SA 4.0, WIKIBOOKS-TL-115328 · revision 989845. Wikibooks contributors (Traktorenlexikon). Original document