WhichTractor
  • Vehicle type: unspecified
  • Rigid chassis
  • WhichTractor size: Utility
  • Not independently tested
  • 1994–2001

It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category

We looked and the record does not say what this machine is. How we decide what a machine is

Case-IH CS-75 A Full specifications

MWM 301.88 T three-cylinder diesel. The manufacturer claimed 74.0 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.

Engine power, claimed · gross or net not stated

74.0 hp

55.2 kW as stated by the source

Not independently tested

Claimed · standard not stated by the source

Source · Traktorenlexikon, “Case-IH CS75a”, claimed

Weight
6,834 lb
Hyd. flow
10.9 gpm
Top speed
18.6–24.9 mph

Case-IH CS-75 A specs: key facts

  • The Case-IH CS-75 A was built from 1994 to 2001.

  • The Case-IH CS-75 A has a claimed engine power (gross or net not stated) of 55.2 kW (74.0 hp); it has no measured PTO figure.

  • The Case-IH CS-75 A is four-wheel drive (4WD).

  • The Case-IH CS-75 A has a MWM 301.88 T engine, a 3-cylinder diesel unit.Source 2

  • The Case-IH CS-75 A weighs 3,100 kg (6,834 lb) unladen.

  • The Case-IH CS-75 A has a rear PTO running at 540 rpm / 1000 rpm.

  • The hydraulic pump of the Case-IH CS-75 A delivers 41.4 L/min (10.9 gpm).

Source · Traktorenlexikon, “Case-IH CS75a”

How much horsepower does a CS-75 A have?

The only figure for the CS-75 A is 74.0 hp (55.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.

Engine, claimed (gross/net not stated)
74.0 hp

Source · Traktorenlexikon, “Case-IH CS75a”

What engine is in a CS-75 A?

A CS-75 A has an MWM 301.88 T, a 3-cylinder diesel engine.

Engine — CS-75 A engine specifications
Make & modelMWM 301.88 TSource 2
Cylinders3, liquid-cooledSource 2
Electrical system12 V

Source · Traktorenlexikon, “Case-IH CS75a”

How much will a CS-75 A lift, and what is its hydraulic flow?

Hydraulic and PTO specifications for the CS-75 A are below.

Hydraulics & PTO — CS-75 A hydraulics and PTO specifications
Pump flow10.9 gpm · 41.4 L/min
Pressure3,481 psi · 240 bar
Rear PTO540 rpm / 1000 rpm

Source · Traktorenlexikon, “Case-IH CS75a”

What transmission does a CS-75 A have?

Transmission specifications for the CS-75 A are below.

Transmission — CS-75 A transmission specifications
ClutchDry double clutch
Top speed18.6–24.9 mph · 30–40 km/hthe article lists alternatives

Source · Traktorenlexikon, “Case-IH CS75a”

How much does a CS-75 A weigh?

A CS-75 A weighs 6,834 lb (3,100 kg) unladen.

Weights & dimensions — CS-75 A weights and dimensions
Unladen weight6,834 lb · 3,100 kg
Maximum permissible mass9,921 lb · 4,500 kg
Wheelbase87.8 in · 2,229 mm
Length149.3 in · 3,792 mm
Width74.8 in · 1,900 mm
Height99.0 in · 2,515 mm
Ground clearance15.7 in · 400 mm
Front track57.7–60.3 in · 1,465–1,532 mmthe article lists alternatives
Rear track53.1–59.3 in · 1,350–1,506 mmthe article lists alternatives

Source · Traktorenlexikon, “Case-IH CS75a”

Which tractors compare with a CS-75 A?

Within 10% of its 74.0 hp of claimed engine power, the same type, and first built within 15 years of it.

Everything else people ask

Is a CS-75 A two-wheel drive or four-wheel drive?

The Case-IH CS-75 A is four-wheel drive (4WD).

What PTO does a CS-75 A have?

A CS-75 A has a 540 rpm / 1000 rpm rear PTO.

Where this page comes from

Compiled from Traktorenlexikon, “Steyr M 975”; and Traktorenlexikon, “Case-IH CS75a”.

Last verified

Not yet verified

Spotted an error?

Sources

Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution

  1. Traktorenlexikon: Case-IH CS75a — CC BY-SA 4.0, WIKIBOOKS-TL-78056 · revision 1010018. Wikibooks contributors (Traktorenlexikon). Original document
  2. Traktorenlexikon: Steyr M 975 — CC BY-SA 4.0, WIKIBOOKS-TL-73689 · revision 1021531. Wikibooks contributors (Traktorenlexikon). Original document