Case-IH CS-75 A vs VALMET 6200-4

9 material differences · fewer than 12

Tractor one

1994–2001

No measured PTO figure

Tractor two

1996–2007

No measured PTO figure

Which should you choose?

Read our verdict on the CS-75 A and the 6200-4 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

9 material differences · 4 fields identical or within 5%, which is not counted as material

Case-IH CS-75 A and VALMET 6200-4, field by field
Field	CS-75 A	6200-4	Gap
Engine
Engine power, claimed claimed	74.0 hp	74.0 hp	—
Engine declared	MWM 301.88 T	VALMET 420 DSRE (44 DT)	differs
Displacement declared	—	4.40 L	—
Transmission
Top speed declared	18.6–24.9 mph · 30–40 km/h	18.6–24.9 mph · 30–40 km/h	—
Clutch declared	Dry double clutch	—	—
Hydraulics & hitch
Pump flow declared	10.9 gpm · 41.4 L/min	21.2 gpm · 80.3 L/min	+94% 6200-4
Pressure declared	3,481 psi · 240 bar	—	—
Three-point lift at ends declared	—	9,601 lb · 4,355 kg	—
Rear PTO speeds declared	540 rpm / 1000 rpm	540 rpm / 1000 rpm	—
Weight & dimensions
Unladen weight declared	6,834 lb · 3,100 kg	8,929–9,193 lb · 4,050–4,170 kg	differs
Maximum permissible mass declared	9,921 lb · 4,500 kg	14,330 lb · 6,500 kg	+44% 6200-4
Wheelbase declared	87.8 in · 2,229 mm	91.6 in · 2,327 mm	—
Length declared	149.3 in · 3,792 mm	177.7 in · 4,514 mm	+19% 6200-4
Width declared	74.8 in · 1,900 mm	85.9 in · 2,181 mm	+15% 6200-4
Height declared	99.0 in · 2,515 mm	106.3 in · 2,700 mm	+7% 6200-4
Ground clearance declared	15.7 in · 400 mm	16.9 in · 430 mm	+8% 6200-4
Turning radius, braked declared	—	15.3 ft · 4.65 m	—
Fuel tank declared	87.7 qt · 83.0 L	167.0 qt · 158.0 L	+90% 6200-4

Source

Source