- Rigid chassis
- WhichTractor size: Utility
- Not independently tested
- 2000–2006
WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
VALMET 6250 HiTech Full specifications
VALMET 420 DSRE or 44 DT four-cylinder diesel.
- Weight
- 9,698 lb
- 3-point lift
- 12,588 lb
- Hyd. flow
- 19.4 gpm
- Top speed
- 18.6–24.9 mph
VALMET 6250 HiTech specs: key facts
The VALMET 6250 HiTech was built from 2000 to 2006.
The VALMET 6250 HiTech is four-wheel drive (4WD).
The VALMET 6250 HiTech has a VALMET 420 DSRE or 44 DT engine, a 4-cylinder 4.40 L diesel unit.
The VALMET 6250 HiTech weighs 4,399 kg (9,698 lb) unladen.
The VALMET 6250 HiTech has an independent rear PTO running at 540/1000 rpm.
The three-point hitch of the VALMET 6250 HiTech lifts 5,710 kg (12,588 lb) at the lower-link ends.
The hydraulic pump of the VALMET 6250 HiTech delivers 73.5 L/min (19.4 gpm).
Source · Traktorenlexikon, “Valmet 6250 HiTech”
How much horsepower does a 6250 HiTech have?
No sourced power figure for the 6250 HiTech is on record yet.
What engine is in a 6250 HiTech?
A 6250 HiTech has a VALMET 420 DSRE or 44 DT, a 4-cylinder 4.40 L diesel engine.
| Make & model | VALMET 420 DSRE or 44 DT |
|---|---|
| Cylinders | 4, liquid-cooled |
| Displacement | 268.3 ci · 4.40 L |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Valmet 6250 HiTech”
How much will a 6250 HiTech lift, and what is its hydraulic flow?
A 6250 HiTech lifts 12,588 lb (5,710 kg) at the lower-link ends of its Category 2 three-point hitch.
| Pump flow | 19.4 gpm · 73.5 L/min |
|---|---|
| Pressure | 2,901 psi · 200 bar |
| Hitch category | Category 2 |
| Lift at ends | 12,588 lb · 5,710 kg |
| Rear PTO | Independent, engine-driven, 540/1000 rpm @ 1,874 engine rpmEngages under load |
Source · Traktorenlexikon, “Valmet 6250 HiTech”
What transmission does a 6250 HiTech have?
Transmission specifications for the 6250 HiTech are below.
| Clutch | Electrically operated dry Fichtel & Sachs single-plate clutch |
|---|---|
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
Source · Traktorenlexikon, “Valmet 6250 HiTech”
How much does a 6250 HiTech weigh?
A 6250 HiTech weighs 9,698 lb (4,399 kg) unladen.
| Unladen weight | 9,698 lb · 4,399 kg |
|---|---|
| Maximum permissible mass | 19,842 lb · 9,000 kg |
| Wheelbase | 91.6 in · 2,326 mm |
| Length | 176.2 in · 4,475 mm |
| Width | 85.8 in · 2,179 mm |
| Height | 109.1 in · 2,771 mm |
| Ground clearance | 17.1 in · 434 mm |
| Front track | 60.6–80.1 in · 1,540–2,035 mm |
| Rear track | 63.4–83.3 in · 1,610–2,115 mm |
| Turning radius, braked | 15.3 ft · 4.65 m |
Source · Traktorenlexikon, “Valmet 6250 HiTech”
Which tractors compare with a 6250 HiTech?
Within 10% of its 75.4 hp at the PTO (claimed), the same type, and first built within 15 years of it.
- Case-IH MX 90 C75.4 hp PTO, claimed · 1998–2000Side by side with the 6250 HiTech →
- SAME Golden 85 Compatto75.5 hp PTO, claimed · 1998–2003Side by side with the 6250 HiTech →
- Hürlimann H-658 XA75.6 hp PTO, claimed · 2000–2004Side by side with the 6250 HiTech →
- New Holland T 504075.6 hp PTO, claimed · 2008–2012Side by side with the 6250 HiTech →
- Deutz-Fahr AgroPrima 4.5175.1 hp PTO, claimed · 1989–1995Side by side with the 6250 HiTech →
- John Deere 2700 (A)75.8 hp PTO, claimed · 1993–1996Side by side with the 6250 HiTech →
Everything else people ask
Is a 6250 HiTech two-wheel drive or four-wheel drive?
The VALMET 6250 HiTech is four-wheel drive (4WD).
What PTO does a 6250 HiTech have?
A 6250 HiTech has a independent 540/1000 rpm rear PTO.
Where this page comes from
Compiled from Traktorenlexikon, “Valmet 6250 HiTech”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Valmet 6250 HiTech — CC BY-SA 4.0, WIKIBOOKS-TL-116480 · revision 999521. Wikibooks contributors (Traktorenlexikon). Original document