- Standard layout, Rigid chassis
- WhichTractor size: Utility
- No lab test on file
- 1956–1962
- 4,738 built
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
International Harvester D-217 Standard specs: hp, weight, years
INTERNATIONAL-HARVESTER DD-74 two-cylinder diesel. The manufacturer claimed 16.8 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
16.8 hp
12.5 kW as stated by the source
No lab test on file
Claimed · standard not stated by the source
Source · Traktorenlexikon, “McCormick D-217 Standard”, claimed
This is the maker’s own figure, measured at the engine. Power at the PTO is lower — by how much, for this machine, nobody has measured.
- Weight
- 2,612 lb
- 3-point lift
- 661 lb
- Hyd. flow
- 5.0 gpm
- Top speed
- 11.2 mph
International Harvester D-217 Standard specs: key facts
The International Harvester D-217 Standard was built from 1956 to 1962.
The International Harvester D-217 Standard has a claimed engine power (gross or net not stated) of 12.5 kW (16.8 hp); it has no measured PTO figure.
The International Harvester D-217 Standard is two-wheel drive (2WD).
The International Harvester D-217 Standard has a INTERNATIONAL-HARVESTER DD-74 engine, a 2-cylinder 1.22 L diesel unit.Source 1
The International Harvester D-217 Standard weighs 1,185 kg (2,612 lb) unladen.
The International Harvester D-217 Standard has a dependent rear PTO running at 540 rpm.
The three-point hitch of the International Harvester D-217 Standard lifts 300 kg (661 lb) at the lower-link ends.
The hydraulic pump of the International Harvester D-217 Standard delivers 19.0 L/min (5.0 gpm).
Source · Traktorenlexikon, “McCormick D-217 Standard”
How much horsepower does a D-217 Standard have?
The only figure for the D-217 Standard is 16.8 hp (12.5 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “McCormick D-217 Standard”
What engine is in a D-217 Standard?
A D-217 Standard has an INTERNATIONAL-HARVESTER DD-74, a 2-cylinder 1.22 L diesel engine.
| Make & model | INTERNATIONAL-HARVESTER DD-74 |
|---|---|
| Cylinders | 2, liquid-cooledSource 2 |
| Displacement | 74.3 ci · 1.22 L |
| Electrical system | 12 VSource 2 |
Source · Traktorenlexikon, “McCormick D-217 Farmall”
How much will a D-217 Standard lift, and what is its hydraulic flow?
A D-217 Standard lifts 661 lb (300 kg) at the lower-link ends.
| Pump flow | 5.0 gpm · 19.0 L/min |
|---|---|
| Lift at ends | 661 lb · 300 kg |
| Rear PTO | Dependent, transmission-driven, 540 rpmGround-speed PTO available |
| PTO shaft | 1 3/8"- 6 splines |
Source · Traktorenlexikon, “McCormick D-217 Standard”
What transmission does a D-217 Standard have?
Transmission specifications for the D-217 Standard are below.
| Brakes | Pedal operated transmission brake combined as individual wheel brake |
|---|---|
| Top speed | 11.2 mph · 18 km/h |
Source · Traktorenlexikon, “McCormick D-217 Standard”
How much does a D-217 Standard weigh?
A D-217 Standard weighs 2,612 lb (1,185 kg) unladen.
| Unladen weight | 2,612 lb · 1,185 kg |
|---|---|
| Wheelbase | 68.1 in · 1,730 mm |
| Length | 105.2 in · 2,672 mm |
| Width | 62.2 in · 1,581 mm |
| Height | 55.0 in · 1,397 mm |
| Ground clearance | 13.9 in · 354 mm |
| Front track | 49.2–59.1 in · 1,250–1,500 mmWikibooks gives one track for both axles; the article lists alternatives |
| Rear track | 49.2–59.1 in · 1,250–1,500 mmWikibooks gives one track for both axles; the article lists alternatives |
| Turning radius, braked | 8.0 ft · 2.45 m |
Source · Traktorenlexikon, “McCormick D-217 Standard”
What oil does a D-217 Standard take, and how much?
Fluid capacities for the D-217 Standard are below.
| System | Capacity |
|---|---|
| Transmission | 7.4 qt · 7 LSource: Traktorenlexikon, “McCormick D-217 Standard” · single source, not independently verified |
| Cooling system | 10.6 qt · 10 LSource: Traktorenlexikon, “McCormick D-217 Standard” · single source, not independently verified |
Always confirm against the operator’s manual for your machine before service.
Which tractors compare with a D-217 Standard?
Within 10% of its 16.8 hp of claimed engine power, the same type, and first built within 15 years of it.
- Fendt Fix 2D16.8 hp engine, claimed · 1963–1967Side by side with the D-217 Standard →
- MASSEY-HARRIS Pacer 1617.3 hp engine, claimed · 1953–1955Side by side with the D-217 Standard →
- Fendt Dieselross F18H17 hp engine, claimed · 1949–1951Side by side with the D-217 Standard →
- SOMECA SOM-20D17.7 hp engine, claimed · 1956–1961Side by side with the D-217 Standard →
- Hanomag C 21817.7 hp engine, claimed · 1957–1959Side by side with the D-217 Standard →
- MAN 2K117.7 hp engine, claimed · 1957–1958Side by side with the D-217 Standard →
Common questions about the International Harvester D-217 Standard
Is a D-217 Standard two-wheel drive or four-wheel drive?
The International Harvester D-217 Standard is two-wheel drive (2WD).
What PTO does a D-217 Standard have?
A D-217 Standard has a dependent 540 rpm rear PTO on a 1 3/8"- 6 splines shaft.
What serial numbers does a D-217 Standard carry?
The source prints serial numbers NT 325.001 to NT 329.786. It does not say whether that is the tractor’s or the engine’s number, and we never work out a year from a serial number.
Sources and how this page was built
Compiled from Traktorenlexikon, “McCormick D-217 Farmall”; and Traktorenlexikon, “McCormick D-217 Standard”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: McCormick D-217 Farmall — CC BY-SA 4.0, WIKIBOOKS-TL-74504 · revision 1056051. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: McCormick D-217 Standard — CC BY-SA 4.0, WIKIBOOKS-TL-86924 · revision 1083831. Wikibooks contributors (Traktorenlexikon). Original document