- Orchard & vineyard, Rigid chassis
- WhichTractor size: Sub-compact
- Not independently tested
- 1995–1999
WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Hürlimann Prince 325 DT Full specifications
MITSUBISHI K3 F-D three-cylinder diesel. The manufacturer claimed 24.7 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
24.7 hp
18.4 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Hürlimann Prince 325”, claimed
- Weight
- 2,337 lb
- Hyd. flow
- 2.1 gpm
- Top speed
- 15.5 mph
Hürlimann Prince 325 DT specs: key facts
The Hürlimann Prince 325 DT was built from 1995 to 1999.
The Hürlimann Prince 325 DT has a claimed engine power (gross or net not stated) of 18.4 kW (24.7 hp); it has no measured PTO figure.
The Hürlimann Prince 325 DT is four-wheel drive (4WD).
The Hürlimann Prince 325 DT has a MITSUBISHI K3 F-D engine, a 3-cylinder 1.12 L diesel unit.
The Hürlimann Prince 325 DT weighs 1,060 kg (2,337 lb) unladen.
The Hürlimann Prince 325 DT has a rear PTO running at 540/1000 rpm.
The hydraulic pump of the Hürlimann Prince 325 DT delivers 8.0 L/min (2.1 gpm).
Source · Traktorenlexikon, “Hürlimann Prince 325”
How much horsepower does a Prince 325 DT have?
The only figure for the Prince 325 DT is 24.7 hp (18.4 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Hürlimann Prince 325”
What engine is in a Prince 325 DT?
A Prince 325 DT has an MITSUBISHI K3 F-D, a 3-cylinder 1.12 L diesel engine.
| Make & model | MITSUBISHI K3 F-D |
|---|---|
| Cylinders | 3, liquid-cooled |
| Displacement | 68.2 ci · 1.12 L |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Hürlimann Prince 325”
How much will a Prince 325 DT lift, and what is its hydraulic flow?
Hydraulic and PTO specifications for the Prince 325 DT are below.
| System | Load sensing |
|---|---|
| Pump flow | 2.1 gpm · 8.0 L/min |
| Pressure | 2,901 psi · 200 bar |
| Hitch category | Category 1 |
| Rear PTO | 540/1000 rpm @ 2,646 engine rpm |
| PTO shaft | 1 3/8"- 6 splines |
Source · Traktorenlexikon, “Hürlimann Prince 325”
What transmission does a Prince 325 DT have?
Transmission specifications for the Prince 325 DT are below.
| Clutch | Pedal-operated, dry SDF single-disc clutch |
|---|---|
| Steering | Hydrostatic Danfoss steering |
| Top speed | 15.5 mph · 25 km/h |
Source · Traktorenlexikon, “Hürlimann Prince 325”
How much does a Prince 325 DT weigh?
A Prince 325 DT weighs 2,337 lb (1,060 kg) unladen.
| Unladen weight | 2,337 lb · 1,060 kg |
|---|---|
| Wheelbase | 60.6 in · 1,540 mm |
| Length | 105.9 in · 2,690 mm |
| Width | 44.1 in · 1,120 mm |
| Height | 77.2 in · 1,960 mm |
| Ground clearance | 12.6 in · 320 mm |
| Front track | 32.3–41.7 in · 820–1,060 mm |
| Rear track | 31.9–39.8 in · 810–1,010 mm |
| Turning radius, braked | 8.5 ft · 2.60 m |
Source · Traktorenlexikon, “Hürlimann Prince 325”
Everything else people ask
Is a Prince 325 DT two-wheel drive or four-wheel drive?
The Hürlimann Prince 325 DT is four-wheel drive (4WD).
What PTO does a Prince 325 DT have?
A Prince 325 DT has a 540/1000 rpm rear PTO on a 1 3/8"- 6 splines shaft.
Where this page comes from
Compiled from Traktorenlexikon, “Hürlimann Prince 325”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Hürlimann Prince 325 — CC BY-SA 4.0, WIKIBOOKS-TL-105402 · revision 896351. Wikibooks contributors (Traktorenlexikon). Original document