• Rigid chassis
  • WhichTractor size: Utility
  • Lab tested ×1
  • 1998–2000

WhichTractor size, not the maker’s category

Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is

Case-IH CX 80 specs: hp, weight, years

PERKINS-FASTRAM 1004-40 Turbo-HR four-cylinder diesel or Perkins 1004-4T HR. The manufacturer claimed 82.9 horsepower. The only laboratory test on record is of one version: OECD Test 1896 measured 73.0 hp at the PTO of the CX 80 (4 WD). Compared at the engine's rated speed, where the brochure figure is quoted, the shaft gave 71.3 hp — 13.9% below the claim.

Engine power, claimed · gross or net not stated

82.9 hp

61.8 kW as stated by the source

No lab test on file

Claimed · standard not stated by the source

Source · Traktorenlexikon, “Case-IH CX80”, claimed

This is the maker’s own figure, measured at the engine. Power at the PTO is lower — by how much, for this machine, nobody has measured.

Weight
8,664 lb
3-point lift
8,543 lb
Hyd. flow
16.1 gpm
Top speed
18.6–24.9 mph

Case-IH CX 80 specs: key facts

  • The Case-IH CX 80 was built from 1998 to 2000.

  • Only one version of the Case-IH CX 80 has a laboratory test on record: the CX 80 (4 WD) produced 54.4 kW (73.0 hp) at the PTO, measured on OECD Test 1896.Source 1

  • The Case-IH CX 80 has a claimed engine power (gross or net not stated) of 61.8 kW (82.9 hp); it has no measured PTO figure.

  • The Case-IH CX 80 is four-wheel drive (4WD).Source 1

  • The Case-IH CX 80 has a PERKINS-FASTRAM 1004-40 Turbo-HR engine, a 4-cylinder 3.99 L diesel unit.

  • The Case-IH CX 80 weighs 3,930 kg (8,664 lb) unladen.

  • The Case-IH CX 80 has an independent rear PTO running at 540/1000 rpm.

  • The three-point hitch of the Case-IH CX 80 lifts 3,875 kg (8,543 lb) at the lower-link ends.

  • The hydraulic pump of the Case-IH CX 80 delivers 60.8 L/min (16.1 gpm).

Source · Traktorenlexikon, “Case-IH CX80”

How does the CX 80 compare with its class?

  • Limitation:

    Eight forward gears is low for its class — 33% below the median of 12 across the 369 machines within 10% of its power that hold this figure.

Derived by WhichTractor from 377 comparable records. How we work this out

Illustration of the 1998–2000 Case-IH CX 80, a 83 hp farm tractor, a drawing generated from its specification record
Illustration — not a photograph

How much horsepower does a CX 80 have?

The only laboratory test on record is of one version. OECD Test 1896 measured 73.0 hp at the PTO of the CX 80 (4 WD). For the CX 80 as a whole the figure is the 82.9 hp claimed for the engine, which is not power at the shaft.

Engine, claimed (gross/net not stated)
82.9 hp

Sources · Traktorenlexikon, “Case-IH CX80”; OECD test report 1896, 2000

What engine is in a CX 80?

A CX 80 has a PERKINS-FASTRAM 1004-40 Turbo-HR, a 4-cylinder 3.99 L diesel engine. CX 80 (4 WD) tractors have a Perkins 1004-4T HR.

Engine — CX 80 engine specifications
Make & modelPERKINS-FASTRAM 1004-40 Turbo-HR
Cylinders4, liquid-cooled
Displacement243.5 ci · 3.99 L
Max torque225 lb·ft · 305 N·m @ 1,406 rpm
InjectionDirect injection
Electrical system12 V

Source · Traktorenlexikon, “Case-IH CX80”

How much will a CX 80 lift, and what is its hydraulic flow?

A CX 80 lifts 8,543 lb (3,875 kg) at the lower-link ends.

Hydraulics & PTO — CX 80 hydraulics and PTO specifications
Pump flow16.1 gpm · 60.8 L/min
Pressure2,698 psi · 186 bar
Lift at ends8,543 lb · 3,875 kg
Rear PTOIndependent, engine-driven, 540/1000 rpm @ 1,994 engine rpmEngages under load
PTO shaft1 3/8"- 6 splines

Source · Traktorenlexikon, “Case-IH CX80”

What transmission does a CX 80 have?

Transmission specifications for the CX 80 are below.

Transmission — CX 80 transmission specifications
ClutchPedal-operated dry single-disc clutch
BrakesPedal-operated hydraulic wet full-disc brake acting on differential side shafts
SteeringHydrostatic Danfoss steering
Top speed18.6–24.9 mph · 30–40 km/hthe article lists alternatives

Source · Traktorenlexikon, “Case-IH CX80”

How much does a CX 80 weigh?

A CX 80 weighs 8,664 lb (3,930 kg) unladen.

Weights & dimensions — CX 80 weights and dimensions
Unladen weight8,664 lb · 3,930 kg
Maximum permissible mass13,228 lb · 6,000 kg
Maximum front axle load6,393 lb · 2,900 kg
Maximum rear axle load10,582 lb · 4,800 kg
Wheelbase92.8 in · 2,356 mm
Length156.7 in · 3,980 mm
Width82.7 in · 2,100 mm
Height99.2 in · 2,520 mm
Ground clearance13.0 in · 330 mm
Front track53.7–76.0 in · 1,364–1,930 mm
Rear track55.9–75.7 in · 1,420–1,922 mm
Turning radius, braked14.7 ft · 4.48 m

Source · Traktorenlexikon, “Case-IH CX80”

What oil does a CX 80 take, and how much?

A CX 80 engine takes 9.3 qt (8.8 L). Single source, not independently verified — always confirm against the operator’s manual for your machine.

CX 80 fluid capacities, grades and service intervals
SystemCapacity
Engine oil9.3 qt · 8.8 LSource: Traktorenlexikon, “Case-IH CX80” · single source, not independently verified
Transmission & hydraulic39.1 qt · 37.0 LSource: Traktorenlexikon, “Case-IH CX80” · single source, not independently verified
Front axle5.8 qt · 5.5 LSource: Traktorenlexikon, “Case-IH CX80” · single source, not independently verified
Cooling system18.5 qt · 17.5 LSource: Traktorenlexikon, “Case-IH CX80” · single source, not independently verified

Always confirm against the operator’s manual for your machine before service.

How much fuel does a CX 80 burn per hour?

Measured on OECD Test 1896 (tested as the CX 80 (4 WD)), at each condition the laboratory recorded.

Cost per hour = fuel used per hour × your fuel price (per litre, or per US gallon for the gal/h figure).

Fuel use measured on OECD Test 1896
Test conditionFuel per hour
Maximum PTO powerPTO 54.4 kW (73.0 hp) at 1,000 rpm16.89 L/h 4.46 gal/h
Rated engine speedPTO 53.2 kW (71.3 hp) at 1,100 rpm17.79 L/h 4.70 gal/h
Standard PTO speedPTO 54.4 kW (73.0 hp) at 1,000 rpm16.89 L/h 4.46 gal/h
75% load, 50% loadNot on record for this test

Source · OECD Test 1896

Which tractors compare with a CX 80?

Within 10% of its 82.9 hp of claimed engine power, the same type, and first built within 15 years of it.

Common questions about the Case-IH CX 80

Is a CX 80 two-wheel drive or four-wheel drive?

The Case-IH CX 80 is four-wheel drive (4WD).

What PTO does a CX 80 have?

A CX 80 has a independent 540/1000 rpm rear PTO on a 1 3/8"- 6 splines shaft.

Sources and how this page was built

Compiled from OECD tractor test report 1896; and Traktorenlexikon, “Case-IH CX80”.

Sources checked

14 SEP 2026

Spotted an error?

Sources

Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution

  1. OECD Code 2 test report 2/1 896: Case IH CX 80 — Licence not stated by the publisher; facts cited, OECD-1896 · published 2000-03-22 · retrieved 2026-09-14. OECD; testing station DLG, Gross-Umstadt, Germany. Original document
  2. Traktorenlexikon: Case-IH CX80 — CC BY-SA 4.0, WIKIBOOKS-TL-89182 · revision 980158. Wikibooks contributors (Traktorenlexikon). Original document