- Rigid chassis
- WhichTractor size: Utility
- Not independently tested
- 1976–1977
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
AGRIFULL 355-C Full specifications
V.M.-MOTORI 1053 three-cylinder diesel. The manufacturer claimed 55.3 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
55.3 hp
41.2 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Agrifull 355 C”, claimed
- Weight
- 5,335 lb
- Hyd. flow
- 5.3 gpm
- Top speed
- 6.2 mph
AGRIFULL 355-C specs: key facts
The AGRIFULL 355-C was built from 1976 to 1977.
The AGRIFULL 355-C has a claimed engine power (gross or net not stated) of 41.2 kW (55.3 hp); it has no measured PTO figure.
The AGRIFULL 355-C is a tracked machine.
The AGRIFULL 355-C has a V.M.-MOTORI 1053 engine, a 3-cylinder 2.86 L diesel unit.
The AGRIFULL 355-C weighs 2,420 kg (5,335 lb) unladen.
The AGRIFULL 355-C has an independent rear PTO running at 540 rpm.
The hydraulic pump of the AGRIFULL 355-C delivers 20.0 L/min (5.3 gpm).
Source · Traktorenlexikon, “Agrifull 355 C”
How much horsepower does a 355-C have?
The only figure for the 355-C is 55.3 hp (41.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Agrifull 355 C”
What engine is in a 355-C?
A 355-C has a V.M.-MOTORI 1053, a 3-cylinder 2.86 L diesel engine.
| Make & model | V.M.-MOTORI 1053 |
|---|---|
| Cylinders | 3, liquid-cooled |
| Displacement | 174.3 ci · 2.86 L |
| Max torque | 127 lb·ft · 172 N·m @ 1,700 rpm |
| Injection | direct injection |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Agrifull 355 C”
How much will a 355-C lift, and what is its hydraulic flow?
Hydraulic and PTO specifications for the 355-C are below.
| Pump flow | 5.3 gpm · 20.0 L/min |
|---|---|
| Rear PTO | Independent, engine-driven, 540 rpm @ 2,044 engine rpmEngages under load |
| PTO shaft | 1 3/8"- 6 splines |
Source · Traktorenlexikon, “Agrifull 355 C”
What transmission does a 355-C have?
Transmission specifications for the 355-C are below.
| Clutch | Hand lever operated dry single disc clutch with dead center engagement |
|---|---|
| Top speed | 6.2 mph · 10 km/h |
Source · Traktorenlexikon, “Agrifull 355 C”
How much does a 355-C weigh?
A 355-C weighs 5,335 lb (2,420 kg) unladen.
| Unladen weight | 5,335 lb · 2,420 kg |
|---|---|
| Wheelbase | 47.2 in · 1,200 mm |
| Length | 86.6 in · 2,200 mm |
| Width | 45.2 in · 1,147 mm |
| Height | 42.7 in · 1,085 mm |
| Ground clearance | 11.0 in · 280 mm |
Source · Traktorenlexikon, “Agrifull 355 C”
Which tractors compare with a 355-C?
Within 10% of its 55.3 hp of claimed engine power, the same type, and first built within 15 years of it.
- Massey Ferguson MF 56055.3 hp engine, claimed · 1976–1979Side by side with the 355-C →
- Renault 80 S/F55.3 hp engine, claimed · 1976–1984Side by side with the 355-C →
- AGRIFULL 80-60 (DT)55.3 hp engine, claimed · 1980–1986Side by side with the 355-C →
- J.I. Case 77056.2 hp engine, claimed · 1969–1973Side by side with the 355-C →
- DEUTZ-ALLIS 615056.2 hp engine, claimed · 1985–1989Side by side with the 355-C →
- AGRIFULL 350-C (CL/Compact/S)54.3 hp engine, claimed · 1976–1977Side by side with the 355-C →
Everything else people ask
Is a 355-C two-wheel drive or four-wheel drive?
The AGRIFULL 355-C is a tracked machine.
What PTO does a 355-C have?
A 355-C has a independent 540 rpm rear PTO on a 1 3/8"- 6 splines shaft.
Where this page comes from
Compiled from Traktorenlexikon, “Agrifull 355 C”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Agrifull 355 C — CC BY-SA 4.0, WIKIBOOKS-TL-122097 · revision 1079043. Wikibooks contributors (Traktorenlexikon). Original document