8 material differences · fewer than 12
Tractor oneFiat 300 (DT)1971–1978No measured PTO figureTractor twoSteyr 188 n1965–1966No measured PTO figure
Which should you choose?
Read our verdict on the 300 (DT) and the 188 n → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 300 (DT) | 188 n | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 30.6 hp | 27.6 hp | +11% 300 (DT) |
| Engine declared | FIAT-IVECO 8025.01.200 or 300 | Steyr WD-209 | differs |
| Displacement declared | 1.73 L | 1.99 L | +15% 188 n |
| Maximum torque declared | 71 lb·ft · 96 N·m | 87 lb·ft · 118 N·m | +23% 188 n |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal-operated dry FIAT single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 2.5 gpm · 9.3 L/min | — | — |
| Pressure declared | — | 2,134 psi · 147 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,690 lb · 1,220 kg | 3,300 lb · 1,497 kg | +23% 188 n |
| Wheelbase declared | 66.9 in · 1,700 mm | 72.6 in · 1,845 mm | +9% 188 n |
| Length declared | 107.9 in · 2,740 mm | 124.4 in · 3,160 mm | +15% 188 n |
| Width declared | 60.6 in · 1,540 mm | 61.3 in · 1,556 mm | — |
| Ground clearance declared | 18.5 in · 470 mm | 12.2 in · 310 mm | +52% 300 (DT) |
| Turning radius, braked declared | 9.5 ft · 2.89 m | 9.7 ft · 2.95 m | — |
| Fuel tank declared | 30.6 qt · 29.0 L | 42.3 qt · 40.0 L | +38% 188 n |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 300 (DT) sources
- Source: Traktorenlexikon, “Fiat 300/300 DT”
Steyr 188 n sources
- Source: Traktorenlexikon, “Steyr 188 n”
- Source: Traktorenlexikon, “Steyr 188”