Fiat 300 (DT) or Steyr 188 n?
Which should you choose?
On performance, every comparable figure that differs favours the Steyr 188 n: three-point lift. It is also ahead on forward gears. On features, the Fiat 300 (DT) is ahead on drive.
- The Steyr 188 n suits loader and hydraulic implement work better on this data: 69% (450 kg / 992 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 300 (DT) | 188 n | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 17.7 kW (23.7 hp)Traktorenlexikon, “Fiat 300/300 DT” | 17.4 kW (23.3 hp)Traktorenlexikon, “Steyr 188 n” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 300 (DT) and the 188 n. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 300 (DT) and the 188 n. |
| Which pumps more oil for implements? | 9.3 L/min (2.5 gpm)Traktorenlexikon, “Fiat 300/300 DT” | — | No figureNo call on hydraulic flow: no figure on record for the 188 n. |
| Which lifts more on the three-point hitch? | 650 kg (1,433 lb)Traktorenlexikon, “Fiat 300/300 DT” | 1,100 kg (2,425 lb)Traktorenlexikon, “Steyr 188 n” | AheadThe Steyr 188 n has 69% more lift (450 kg / 992 lb) than the Fiat 300 (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 1,220 kg (2,690 lb)Traktorenlexikon, “Fiat 300/300 DT” | 1,497 kg (3,300 lb)Traktorenlexikon, “Steyr 188 n” | Ahead (a fact, not an advantage)The Steyr 188 n is 23% heavier (277 kg / 611 lb) than the Fiat 300 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 300 (DT) and the 188 n. |
| Which has the wider choice of gears? | 6Traktorenlexikon, “Fiat 300/300 DT” | 8Traktorenlexikon, “Steyr 188 n” | AheadThe Steyr 188 n has 33% more forward gears (2 gears) than the Fiat 300 (DT) (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 300 (DT) and the 188 n. |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Fiat 300/300 DT” | 25 km/h (15.5 mph)Traktorenlexikon, “Steyr 188 n” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Fiat 300/300 DT” | 540 rpmTraktorenlexikon, “Steyr 188 n” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “Fiat 300/300 DT” | dependent (stops with the clutch)Traktorenlexikon, “Steyr 188 n” | EvenEven on PTO independence: every PTO is dependent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 300/300 DT” | 2WDTraktorenlexikon, “Steyr 188 n” | AheadThe Fiat 300 (DT) is available with four-wheel drive; the Steyr 188 n is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1971–1978 | 1965–1966 | Ahead (a fact, not an advantage)The Fiat 300 (DT) is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Steyr 188 n has 69% more lift (450 kg / 992 lb) than the Fiat 300 (DT) (both lift at the hitch ends, as stated by the source).
- The Steyr 188 n is 23% heavier (277 kg / 611 lb) than the Fiat 300 (DT) (both unladen weight, as stated by the source).
- The Steyr 188 n has 33% more forward gears (2 gears) than the Fiat 300 (DT) (both forward gears, as stated by the source).
- The Fiat 300 (DT) is available with four-wheel drive; the Steyr 188 n is two-wheel drive (as stated by the sources).
- The Fiat 300 (DT) is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540 rpm).
- Even on PTO independence: every PTO is dependent.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources