7 material differences · fewer than 12
Tractor oneFendt Fix 2 D1963–1967No measured PTO figureTractor twoKramer KL 2001958–1967No measured PTO figure
Which should you choose?
Read our verdict on the Fix 2 D and the KL 200 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Fix 2 D | KL 200 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 16.8 hp | 17.7 hp | +6% KL 200 |
| Engine declared | MWM AKD 311 Z | — | — |
| Displacement declared | 1.40 L | — | — |
| Maximum torque declared | — | 64 lb·ft · 86 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | single-plate dry clutch | Single-plate dry clutch from Fichtel & Sachs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 2.9 gpm · 11.0 L/min | 4.2 gpm · 16 L/min | +45% KL 200 |
| Pressure declared | 2,134 psi · 147 bar | 1,707 psi · 118 bar | +25% Fix 2 D |
| Rear PTO speeds declared | 570 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,789 lb · 1,265 kg | 2,800–3,153 lb · 1,270–1,430 kg | differs |
| Maximum permissible mass declared | — | 4,012 lb · 1,820 kg | — |
| Wheelbase declared | 68.9 in · 1,750 mm | 69.5–71.9 in · 1,765–1,825 mm | — |
| Length declared | 113.8 in · 2,890 mm | 111.0–113.4 in · 2,820–2,880 mm | — |
| Width declared | 59.8 in · 1,520 mm | 58.7–59.1 in · 1,490–1,500 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 13.8–15.7 in · 350–400 mm | differs |
| Fuel tank declared | 31.7 qt · 30 L | 25.4 qt · 24 L | +25% Fix 2 D |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Fix 2 D sources
- Source: Traktorenlexikon, “Fendt Fix 2 D”
- Source: Traktorenlexikon, “Fendt Dieselross F17”
Kramer KL 200 sources
- Source: Traktorenlexikon, “Kramer KL 200”