11 material differences · fewer than 12
Tractor oneEicher 635 K1986–1993No measured PTO figureTractor twoHürlimann Prince 435 DT1995–1999No measured PTO figure
Which should you choose?
Read our verdict on the 635 K and the Prince 435 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 635 K | Prince 435 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 35 hp | 34.6 hp | — |
| Engine declared | Eicher EDL 2 - 1 | MITSUBISHI K4 F-D | differs |
| Displacement declared | 1.96 L | 1.49 L | +32% 635 K |
| Maximum torque declared | 97 lb·ft · 132 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.8 mph · 25.4 km/h | 18.6 mph · 30 km/h | +18% Prince 435 DT |
| Clutch declared | — | Pedal-operated dry SDF single-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 11.6 gpm · 44.0 L/min | 1.4 gpm · 5.3 L/min | +730% 635 K |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,329 lb · 1,510 kg | 2,601 lb · 1,180 kg | +28% 635 K |
| Wheelbase declared | 65.6 in · 1,665 mm | 64.2 in · 1,630 mm | — |
| Length declared | 98.2 in · 2,495 mm | 116.5 in · 2,960 mm | +19% Prince 435 DT |
| Width declared | 35.6–45.3 in · 905–1,150 mm | 40.2–53.5 in · 1,020–1,360 mm | differs |
| Ground clearance declared | 10.2 in · 260 mm | 14.2 in · 360 mm | +38% Prince 435 DT |
| Turning radius, braked declared | 8.2 ft · 2.50 m | 9.0 ft · 2.73 m | +9% Prince 435 DT |
| Fuel tank declared | 52.8 qt · 50 L | 30.6 qt · 29.0 L | +72% 635 K |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Eicher 635 K sources
- Source: Traktorenlexikon, “Eicher 635 K”
- Source: Traktorenlexikon, “Eicher 535 ASK”
Hürlimann Prince 435 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 435”