11 material differences · fewer than 12
Tractor oneDeutz-Fahr AgroStar 6.381993–1995No measured PTO figureTractor twoJohn Deere 64101997–200398.0 hpMeasured at the PTO · OECD Test 1806
Which should you choose?
Read our verdict on the AgroStar 6.38 and the 6410 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | AgroStar 6.38 | 6410 | Gap |
|---|---|---|---|
| Measured performance | |||
| PTO power, measured measured | — | 98.0 hp | — |
| Drawbar power, measured measured | — | 79.7 hp | — |
| Engine | |||
| Engine power, claimed claimed | 123 hp | — | — |
| Engine declared | K.H.D. BF6L 913 T | John Deere 4045TL056 | differs |
| Displacement declared | 6.13 L | 4.53 L | +35% AgroStar 6.38 |
| Maximum torque declared | 340 lb·ft · 461 N·m | 307 lb·ft · 416.0 N·m | +11% AgroStar 6.38 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–31.1 mph · 30–50 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 15.3 gpm · 58.0 L/min | — | — |
| Pressure declared | — | 3,017–3,220 psi · 208–222 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540E/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 10,229 lb · 4,640 kg | 9,039–9,678 lb · 4,100–4,390 kg | differs |
| Maximum permissible mass declared | 18,739 lb · 8,500 kg | 17,637 lb · 8,000 kg | +6% AgroStar 6.38 |
| Wheelbase declared | 107.0 in · 2,718 mm | 95.7 in · 2,430 mm | +12% AgroStar 6.38 |
| Length declared | 179.4 in · 4,556 mm | 181.5 in · 4,610 mm | — |
| Width declared | 97.2 in · 2,470 mm | 87.4 in · 2,220 mm | +11% AgroStar 6.38 |
| Ground clearance declared | 20.9 in · 530 mm | 17.2 in · 436 mm | +22% AgroStar 6.38 |
| Fuel tank declared | 179.6 qt · 170 L | 195.5 qt · 185.0 L | +9% 6410 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr AgroStar 6.38 sources
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 6.38”
- Source: Traktorenlexikon, “Deutz-Allis 7120”
John Deere 6410 sources
- Source: OECD test report 1806, 1999
- Source: OECD test report 1842, 1999
- Source: Traktorenlexikon, “John Deere 6410”