Deutz-Fahr AgroStar 6.38 or John Deere 6410?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the AgroStar 6.38: power at the PTO, claimed (Traktorenlexikon, “Deutz-Fahr AgroStar 6.38”); the 6410: power at the PTO, measured by a laboratory at maximum power (OECD Test 1806) — not the same quantity, basis and condition.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | AgroStar 6.38 | 6410 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 76 kW (102 hp)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 73.1 kW (98.0 hp)OECD Test 1806 | Not comparableNot comparable on power at the PTO shaft: the AgroStar 6.38: power at the PTO, claimed (Traktorenlexikon, “Deutz-Fahr AgroStar 6.38”); the 6410: power at the PTO, measured by a laboratory at maximum power (OECD Test 1806) — not the same quantity, basis and condition. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroStar 6.38 and the 6410. |
| Which pulls harder at the drawbar? | — | 59.4 kW (79.7 hp)OECD Test 1806 | No figureNo call on drawbar power: no figure on record for the AgroStar 6.38. |
| Which pumps more oil for implements? | 58.0 L/min (15.3 gpm)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | — | No figureNo call on hydraulic flow: no figure on record for the 6410. |
| Which lifts more on the three-point hitch? | 6,500 kg (14,330 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 6,016 kg (13,264 lb)Traktorenlexikon, “John Deere 6410” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 4,640 kg (10,229 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 4,100 kg (9,039 lb) to 4,390 kg (9,678 lb), varies by configurationTraktorenlexikon, “John Deere 6410” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 8,500 kg (18,739 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 8,000 kg (17,637 lb)Traktorenlexikon, “John Deere 6410” | EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which has the wider choice of gears? | 40 to 48Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 24OECD test report 1842, 1999 | Sources disagreeNo call on forward gears: sources disagree on the figure for the 6410. |
| Which offers a creeper range? | YesTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | — | No figureNo call on a creeper range: not stated for the 6410. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 30 km/h (18.6 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “John Deere 6410” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | 540E/540/1000 rpmTraktorenlexikon, “John Deere 6410” | AheadThe John Deere 6410 offers 540 rpm at the PTO, which the Deutz-Fahr AgroStar 6.38 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | — | No figureNo call on PTO independence: not stated for the 6410. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr AgroStar 6.38” | Two-wheel or four-wheel driveTraktorenlexikon, “John Deere 6410” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1993–1995 | 1997–2003 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The John Deere 6410 offers 540 rpm at the PTO, which the Deutz-Fahr AgroStar 6.38 does not (as stated by the sources).
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the AgroStar 6.38: power at the PTO, claimed (Traktorenlexikon, “Deutz-Fahr AgroStar 6.38”); the 6410: power at the PTO, measured by a laboratory at maximum power (OECD Test 1806) — not the same quantity, basis and condition.
- No call on forward gears: sources disagree on the figure for the 6410.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources