9 material differences · fewer than 12
Tractor oneDeutz (KHD) D 30051965–1967No measured PTO figureTractor twoInternational Harvester Super FC-C1952–1957No measured PTO figure
Which should you choose?
Read our verdict on the D 3005 and the Super FC-C → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | D 3005 | Super FC-C | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 27.5 hp | 24 hp | +14% D 3005 |
| Engine declared | — | INTERNATIONAL HARVESTER C-123 | — |
| Displacement declared | — | 2.01 L | — |
| Maximum torque declared | 67 lb·ft · 91 N·m | 116 lb·ft · 157 N·m | +73% Super FC-C |
| Transmission | |||
| Top speed declared | 12.4–16.1 mph · 20.0–25.9 km/h | 10.6 mph · 17 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.6 gpm · 17.3 L/min | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 539 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,605 lb · 1,635 kg | 3,175 lb · 1,440 kg | +14% D 3005 |
| Maximum permissible mass declared | 6,614 lb · 3,000 kg | — | — |
| Wheelbase declared | 73.4 in · 1,865 mm | 91.5 in · 2,324 mm | +25% Super FC-C |
| Length declared | 127.8 in · 3,245 mm | 129.5 in · 3,290 mm | — |
| Width declared | 60.4 in · 1,535 mm | 78.0–87.8 in · 1,980–2,230 mm | differs |
| Ground clearance declared | 15.9 in · 405 mm | 22.4 in · 570 mm | +41% Super FC-C |
| Turning radius, braked declared | 10.7 ft · 3.25 m | 12.0 ft · 3.65 m | +12% Super FC-C |
| Fuel tank declared | 67.6 qt · 64 L | 44.1 qt · 41.75 L | +53% D 3005 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 3005 sources
- Source: Traktorenlexikon, “Deutz D 3005”
International Harvester Super FC-C sources
- Source: Traktorenlexikon, “McCormick Super FC-C”
- Source: Traktorenlexikon, “McCormick Farmall Super-A 1”