Deutz (KHD) D 3005 or International Harvester Super FC-C?
Which should you choose?
On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the Deutz D 3005 is ahead on forward gears, top speed and PTO independence.
- The Deutz D 3005 suits PTO-driven implements (mowers, balers, pumps) better on this data: an independent PTO.
- The Deutz D 3005 suits road haulage better on this data: 18% (3.0 km/h / 1.9 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | D 3005 | Super FC-C | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 18.8 kW (25.2 hp)Traktorenlexikon, “Deutz D 3005” | 18.0 kW (24.2 hp)Traktorenlexikon, “McCormick Super FC-C” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the D 3005 and the Super FC-C. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the D 3005 and the Super FC-C. |
| Which pumps more oil for implements? | — | 17.3 L/min (4.6 gpm)Traktorenlexikon, “McCormick Super FC-C” | No figureNo call on hydraulic flow: no figure on record for the D 3005. |
| Which lifts more on the three-point hitch? | 1,425 kg (3,142 lb)Traktorenlexikon, “Deutz D 3005” | 700 kg (1,543 lb)Traktorenlexikon, “McCormick Super FC-C” | EvenNo call on three-point lift: the sources do not state where the lift was measured, so the difference is not a reliable call. |
| Which is heavier, for traction? | 1,635 kg (3,605 lb)Traktorenlexikon, “Deutz D 3005” | 1,440 kg (3,175 lb)Traktorenlexikon, “McCormick Super FC-C” | Ahead (a fact, not an advantage)The Deutz D 3005 is 14% heavier (195 kg / 430 lb) than the International Harvester Super FC-C (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 3,000 kg (6,614 lb)Traktorenlexikon, “Deutz D 3005” | — | No figureNo call on maximum permissible mass: no figure on record for the Super FC-C. |
| Which has the wider choice of gears? | 8Traktorenlexikon, “Deutz D 3005” | 4Traktorenlexikon, “McCormick Super FC-C” | AheadThe Deutz D 3005 has 100% more forward gears (4 gears) than the International Harvester Super FC-C (both forward gears, as stated by the source). |
| Which offers a creeper range? | YesTraktorenlexikon, “Deutz D 3005” | — | No figureNo call on a creeper range: not stated for the Super FC-C. |
| Which is faster on the road? | 20.0 km/h (12.4 mph) to 25.9 km/h (16.1 mph)Traktorenlexikon, “Deutz D 3005” | 17 km/h (10.6 mph)Traktorenlexikon, “McCormick Super FC-C” | AheadThe Deutz D 3005 has 18% more top speed (3.0 km/h / 1.9 mph) than the International Harvester Super FC-C (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Deutz D 3005” | 539 rpmTraktorenlexikon, “McCormick Super FC-C” | No figureNo call on PTO speeds: no standard PTO speed stated for the Super FC-C. |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz D 3005” | dependent (stops with the clutch)Traktorenlexikon, “McCormick Super FC-C” | AheadThe Deutz D 3005 has an independent PTO; the International Harvester Super FC-C’s is dependent (stops with the clutch). |
| Which drives on both axles? | 2WDTraktorenlexikon, “Deutz D 3005” | 2WDTraktorenlexikon, “McCormick Super FC-C” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1965–1967 | 1952–1957 | Ahead (a fact, not an advantage)The Deutz D 3005 is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz D 3005 is 14% heavier (195 kg / 430 lb) than the International Harvester Super FC-C (both unladen weight, as stated by the source).
- The Deutz D 3005 has 100% more forward gears (4 gears) than the International Harvester Super FC-C (both forward gears, as stated by the source).
- The Deutz D 3005 has 18% more top speed (3.0 km/h / 1.9 mph) than the International Harvester Super FC-C (both top speed forward, as stated by the source).
- The Deutz D 3005 has an independent PTO; the International Harvester Super FC-C’s is dependent (stops with the clutch).
- The Deutz D 3005 is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- No call on three-point lift: the sources do not state where the lift was measured, so the difference is not a reliable call.
- Even on drive: all two-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO speeds.
← Every figure for both machines, side by side, with sources