- Vehicle type: unspecified
- Rigid chassis
- WhichTractor size: Standard-size
- Not independently tested
- 1954–1957
- 69 built
It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category
Fahr D 400 C Hydraulics & PTO specifications
6 hydraulics and PTO values on record for the D 400 C.
Engine power, claimed · gross or net not stated
44.1 hp
32.9 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Fahr D 400 C”, claimed
What hydraulics does a D 400 C have?
Hydraulic and hitch specifications for the D 400 C are below.
| Pump flow | 4.9 gpm · 18.5 L/min |
|---|---|
| Hydraulic pressure | 1,707 psi · 118 bar |
Source · Traktorenlexikon, “Fahr D 400 C”
What PTO does a D 400 C have?
A D 400 C has a 575 rpm rear PTO.
| Rear PTO drive | Transmission-driven |
|---|---|
| Rear PTO independence | Dependent |
| Rear PTO speeds | 575 rpm |
| Rear PTO shaft | 29 x 34,9 x 8,7 mm |
Source · Traktorenlexikon, “Fahr D 400 C”
Where this page comes from
6 hydraulics and PTO values from Traktorenlexikon, “Fahr D 400 C”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Fahr D 400 C — CC BY-SA 4.0, WIKIBOOKS-TL-43359 · revision 1078528. Wikibooks contributors (Traktorenlexikon). Original document