11 material differences · fewer than 12
Tractor oneVALMET 505/505-41983–1989No measured PTO figureTractor twoZETOR 7011/70451980–1984No measured PTO figure
Which should you choose?
Read our verdict on the 505/505-4 and the 7011/7045 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 505/505-4 | 7011/7045 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | VALMET TD 33 DS 5 | ZBROJORKA Z-7001 | differs |
| Displacement declared | 3.30 L | 3.60 L | +9% 7011/7045 |
| Maximum torque declared | — | 148 lb·ft · 200 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 505/505-4 |
| Clutch declared | Pedal-operated dry LuK single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 13.9 gpm · 52.7 L/min | 6.0 gpm · 22.9 L/min | +130% 505/505-4 |
| Pressure declared | 2,901 psi · 200 bar | 3,336 psi · 230 bar | +15% 7011/7045 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,760 lb · 3,520 kg | 6,460 lb · 2,930 kg | +20% 505/505-4 |
| Wheelbase declared | 93.2 in · 2,368 mm | 88.5 in · 2,247 mm | +5% 505/505-4 |
| Length declared | 172.8 in · 4,390 mm | 146.5 in · 3,720 mm | +18% 505/505-4 |
| Width declared | 77.2 in · 1,960 mm | 72.8 in · 1,850 mm | +6% 505/505-4 |
| Ground clearance declared | 18.3 in · 465 mm | 19.3 in · 490 mm | +5% 7011/7045 |
| Turning radius, braked declared | — | 11.7 ft · 3.57 m | — |
| Fuel tank declared | 190.2 qt · 180.0 L | 74.0 qt · 70.0 L | +157% 505/505-4 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
VALMET 505/505-4 sources
- Source: Traktorenlexikon, “Valmet 505”
ZETOR 7011/7045 sources
- Source: Traktorenlexikon, “Zetor 7011”