10 material differences · fewer than 12
Tractor oneSAME Panther 95 (DT)1979–1981No measured PTO figureTractor twoVALMET 903/903-41979–1983No measured PTO figure
Which should you choose?
Read our verdict on the Panther 95 (DT) and the 903/903-4 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Panther 95 (DT) | 903/903-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.7 hp | — |
| Engine declared | SAME DA 1055 P | VALMET 411 CS | differs |
| Displacement declared | 5.19 L | 4.40 L | +18% Panther 95 (DT) |
| Maximum torque declared | 251 lb·ft · 340 N·m | 236 lb·ft · 320 N·m | +6% Panther 95 (DT) |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 18.6 mph · 30 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 9.2 gpm · 35.0 L/min | 11.4 gpm · 43.0 L/min | +23% 903/903-4 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,242 lb · 3,285 kg | 8,047 lb · 3,650 kg | +11% 903/903-4 |
| Wheelbase declared | 98.4 in · 2,500 mm | 91.7 in · 2,330 mm | +7% Panther 95 (DT) |
| Length declared | 161.4 in · 4,100 mm | 153.7 in · 3,905 mm | — |
| Width declared | 82.7–102.4 in · 2,100–2,600 mm | 77.6 in · 1,972 mm | differs |
| Ground clearance declared | 17.9 in · 455 mm | 18.1 in · 460 mm | — |
| Turning radius, braked declared | 12.4 ft · 3.77 m | 12.5 ft · 3.82 m | — |
| Fuel tank declared | 101.4 qt · 96.0 L | 95.1 qt · 90.0 L | +7% Panther 95 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SAME Panther 95 (DT) sources
- Source: Traktorenlexikon, “SAME Panther 95”
VALMET 903/903-4 sources
- Source: Traktorenlexikon, “Valmet 903”
- Source: Traktorenlexikon, “Valmet 802”