6 material differences · fewer than 12
Tractor oneSAME Atlanta-V (DT)1965–1968No measured PTO figureTractor twoVALMET 361 D1960–1965No measured PTO figure
Which should you choose?
Read our verdict on the Atlanta-V (DT) and the 361 D → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Atlanta-V (DT) | 361 D | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 41.4 hp | 41.4 hp | — |
| Engine declared | SAME 954/V | VALMET 310 D or 310 A | differs |
| Displacement declared | 3.40 L | 2.69 L | +27% Atlanta-V (DT) |
| Maximum torque declared | — | 116 lb·ft · 157 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 361 D |
| Clutch declared | — | Pedal operated dry single plate clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 3.2 gpm · 12.0 L/min | 5.8 gpm · 22.0 L/min | +83% 361 D |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,483 lb · 1,580 kg | 3,902 lb · 1,770 kg | +12% 361 D |
| Wheelbase declared | 72.0 in · 1,830 mm | 74.6 in · 1,895 mm | — |
| Length declared | 109.4 in · 2,780 mm | 114.6 in · 2,910 mm | — |
| Width declared | 58.7 in · 1,490 mm | 67.9–88.2 in · 1,725–2,240 mm | differs |
| Ground clearance declared | 16.9 in · 430 mm | 17.7 in · 450 mm | — |
| Turning radius, braked declared | — | 10.0 ft · 3.04 m | — |
| Fuel tank declared | — | 40.2 qt · 38.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SAME Atlanta-V (DT) sources
- Source: Traktorenlexikon, “SAME Atlanta V (DT)”
- Source: Traktorenlexikon, “SAME Atlanta 45 (DT)”
VALMET 361 D sources
- Source: Traktorenlexikon, “Valmet 361 D”