7 material differences · fewer than 12
Tractor oneMassey Ferguson MF 575 (A)1976–1983No measured PTO figureTractor twoVALMET 702 (A)1972–1980No measured PTO figure
Which should you choose?
Read our verdict on the MF 575 (A) and the 702 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | MF 575 (A) | 702 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 65.2 hp | 70.0 hp | +7% 702 (A) |
| Engine declared | Perkins A 4.236 | VALMET 411 B or C | differs |
| Displacement declared | 3.87 L | 4.18 L | +8% 702 (A) |
| Maximum torque declared | 198 lb·ft · 268.2 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 702 (A) |
| Clutch declared | Pedal-operated, dry and air-cooled single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 16.5 gpm · 62.5 L/min | 6.9 gpm · 26.0 L/min | +140% MF 575 (A) |
| Three-point lift, at the coupling points declared | 4,630 lb · 2,100 kg | 4,740 lb · 2,150 kg | — |
| Rear PTO speeds declared | 540/1686 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,923 lb · 3,140 kg | 7,419–7,606 lb · 3,365–3,450 kg | differs |
| Wheelbase declared | 87.5 in · 2,222 mm | 88.2 in · 2,240 mm | — |
| Length declared | 149.2 in · 3,790 mm | 150.4 in · 3,820 mm | — |
| Width declared | 74.0 in · 1,880 mm | 73.6 in · 1,869 mm | — |
| Ground clearance declared | 15.4 in · 390 mm | 18.1 in · 460 mm | +18% 702 (A) |
| Turning radius, braked declared | 12.3 ft · 3.74 m | 11.8 ft · 3.61 m | — |
| Fuel tank declared | 103.8 qt · 98.2 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Massey Ferguson MF 575 (A) sources
- Source: Traktorenlexikon, “Massey Ferguson MF 575 & 575A”
- Source: Traktorenlexikon, “Massey Ferguson MF 168 & MF 168A”
VALMET 702 (A) sources
- Source: Traktorenlexikon, “Valmet 702”