8 material differences · fewer than 12
Tractor oneMAN Werk München 4P11960–1963No measured PTO figureTractor twoUZINA TRACTORUL 420 (DT)1974–1981No measured PTO figure
Which should you choose?
Read our verdict on the 4P1 and the 420 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 4P1 | 420 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.3 hp | 41.3 hp | +20% 420 (DT) |
| Engine declared | MAN D 8613 M 1/2 | UTB D-115 | differs |
| Displacement declared | 1.92 L | 2.34 L | +22% 420 (DT) |
| Maximum torque declared | — | 108 lb·ft · 147 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–17.6 mph · 19.9–28.3 km/h | 15.5 mph · 25 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 16.0 L/min | — |
| Pressure declared | — | 2,973 psi · 205 bar | — |
| Rear PTO speeds declared | 1520 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,233 lb · 1,920 kg | 3,616 lb · 1,640 kg | +17% 4P1 |
| Maximum permissible mass declared | 6,173 lb · 2,800 kg | — | — |
| Wheelbase declared | 77.6 in · 1,970 mm | 74.8 in · 1,900 mm | — |
| Length declared | 131.7 in · 3,345 mm | 122.4 in · 3,110 mm | +8% 4P1 |
| Width declared | 65.7 in · 1,670 mm | 68.1 in · 1,730 mm | — |
| Ground clearance declared | 11.0–15.7 in · 280–400 mm | 20.9 in · 530 mm | differs |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 10.6 ft · 3.22 m | — |
| Fuel tank declared | 63.4–2,073.2 qt · 60–1,962 L | 57.1 qt · 54.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
MAN Werk München 4P1 sources
- Source: Traktorenlexikon, “MAN 4P1”
- Source: Traktorenlexikon, “MAN 2P1”
UZINA TRACTORUL 420 (DT) sources
- Source: Traktorenlexikon, “UTB 420 (DT)”
- Source: Traktorenlexikon, “UTB U 445”