5 material differences · fewer than 12
Tractor oneJohn Deere 8345 Rfrom 2009No measured PTO figureTractor twoNew Holland T 80502007–2011No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Tracks; 4WD); the 8345 R is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 8345 R | T 8050 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 341 hp | 321 hp | +6% 8345 R |
| Engine declared | — | CUMMINS 6 TAA-9004 (TIER-III) | — |
| Displacement declared | — | 8.85 L | — |
| Maximum torque declared | 1,117 lb·ft · 1,515 N·m | 994 lb·ft · 1,348 N·m | +12% 8345 R |
| Transmission | |||
| Top speed declared | 31.1 mph · 50 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | — | Electro-hydraulically operated wet multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | — | 44.0 gpm · 166.6 L/min | — |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 27,558 lb · 12,500 kg | 24,268 lb · 11,008 kg | +14% 8345 R |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 118.9 in · 3,020 mm | 121.2 in · 3,078 mm | — |
| Length declared | 220.1 in · 5,590 mm | 229.5 in · 5,829 mm | — |
| Width declared | 97.6 in · 2,480 mm | 98.0 in · 2,490 mm | — |
| Ground clearance declared | — | 14.6 in · 372 mm | — |
| Fuel tank declared | 801.0 qt · 758 L | 720.7 qt · 682.0 L | +11% 8345 R |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 8345 R sources
- Source: Traktorenlexikon, “John Deere 8345 R”
- Source: OECD test report 2655, 2011
New Holland T 8050 sources
- Source: Traktorenlexikon, “New Holland T8050”