7 material differences · fewer than 12
Tractor oneJohn Deere 8345 Rfrom 2009No measured PTO figureTractor twoJohn Deere 9320 T2002–2007No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (55%); they were not built in overlapping years (2009–2009; 2002–2007); the 8345 R is on tracks, not an alternative to an ordinary tractor; the 9320 T is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 8345 R | 9320 T | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 341 hp | 370 hp | +9% 9320 T |
| Engine declared | — | John Deere-PowerTech 6.125 HRW-13 | — |
| Displacement declared | — | 12.54 L | — |
| Maximum torque declared | 1,117 lb·ft · 1,515 N·m | 1,291 lb·ft · 1,750 N·m | +16% 9320 T |
| Transmission | |||
| Top speed declared | 31.1 mph · 50 km/h | 18.6 mph · 30 km/h | +67% 8345 R |
| Clutch declared | — | Pedal-operated hydraulic wet John Deere multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Closed centre | — |
| Hydraulic control declared | Load sensing | Load sensing | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 27,558 lb · 12,500 kg | 42,849 lb · 19,436 kg | +55% 9320 T |
| Wheelbase declared | 118.9 in · 3,020 mm | 110.6 in · 2,810 mm | +7% 8345 R |
| Length declared | 220.1 in · 5,590 mm | 237.0 in · 6,020 mm | +8% 9320 T |
| Width declared | 97.6 in · 2,480 mm | 136.0 in · 3,454 mm | +39% 9320 T |
| Ground clearance declared | — | 14.8 in · 375 mm | — |
| Fuel tank declared | 801.0 qt · 758 L | 1,092.6 qt · 1,034.0 L | +36% 9320 T |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 8345 R sources
- Source: Traktorenlexikon, “John Deere 8345 R”
- Source: OECD test report 2655, 2011
John Deere 9320 T sources
- Source: Traktorenlexikon, “John Deere 9320T”
- Source: OECD test report 2041, 2003