10 material differences · fewer than 12
Tractor oneJohn Deere 5525 (A)2005–2008No measured PTO figureTractor twoLamborghini 874-95 N/DT2004–2007No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 5525 (A) | 874-95 N/DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 91 hp | 89.7 hp | — |
| Engine declared | John Deere-PowerTech 4.045 T 41 | SAME 1000.4 WT (Tier-II) | differs |
| Displacement declared | 4.52 L | 4.00 L | +13% 5525 (A) |
| Maximum torque declared | 229 lb·ft · 310 N·m | 233 lb·ft · 316 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Pedal-operated dry double clutch | Pedal operated dry AP Automotive Products Italy single disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 18.6 gpm · 70.4 L/min | 11.7 gpm · 44.2 L/min | +59% 5525 (A) |
| Pressure declared | 3,408 psi · 235 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,799 lb · 3,084 kg | 7,011 lb · 3,180 kg | — |
| Wheelbase declared | 85.7 in · 2,178 mm | 90.4 in · 2,297 mm | +5% 874-95 N/DT |
| Length declared | 151.5 in · 3,848 mm | 160.6 in · 4,080 mm | +6% 874-95 N/DT |
| Width declared | 74.1 in · 1,882 mm | 77.2–96.9 in · 1,960–2,460 mm | differs |
| Ground clearance declared | 18.5 in · 470 mm | 19.7 in · 500 mm | +6% 874-95 N/DT |
| Turning radius, braked declared | 10.2 ft · 3.10 m | — | — |
| Fuel tank declared | 100.0 qt · 94.6 L | 64.5 qt · 61.0 L | +55% 5525 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 5525 (A) sources
- Source: Traktorenlexikon, “John Deere 5525”
Lamborghini 874-95 N/DT sources
- Source: Traktorenlexikon, “Lamborghini 874-95 N”