9 material differences · fewer than 12
Tractor oneJohn Deere 30101962–1964No measured PTO figureTractor twoUTB U 650/6511963–1973No measured PTO figure
Which should you choose?
Read our verdict on the 3010 and the U 650/651 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 3010 | U 650/651 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | — | UTB D-103 | — |
| Displacement declared | — | 4.76 L | — |
| Maximum torque declared | 171 lb·ft · 231 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 16.8 mph · 27 km/h | +11% 3010 |
| Clutch declared | Dry double clutch | Pedal-operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 18.0 gpm · 68.0 L/min | 10.6 gpm · 40.0 L/min | +70% 3010 |
| Pressure declared | 2,247 psi · 155 bar | 1,856 psi · 128 bar | +21% 3010 |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,967 lb · 3,160 kg | 6,724 lb · 3,050 kg | — |
| Maximum permissible mass declared | — | 9,921 lb · 4,500 kg | — |
| Wheelbase declared | 81.5 in · 2,070 mm | 95.7 in · 2,430 mm | +17% U 650/651 |
| Length declared | 147.6 in · 3,750 mm | 166.5 in · 4,230 mm | +13% U 650/651 |
| Width declared | 83.7 in · 2,125 mm | 78.7 in · 2,000 mm | +6% 3010 |
| Ground clearance declared | 19.3 in · 490 mm | 18.9 in · 480 mm | — |
| Turning radius, braked declared | 10.7 ft · 3.25 m | 11.9 ft · 3.64 m | +12% U 650/651 |
| Fuel tank declared | 116.2 qt · 110.0 L | 103.6 qt · 98.0 L | +12% 3010 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 3010 sources
- Source: Traktorenlexikon, “John Deere 3010”
UTB U 650/651 sources
- Source: Traktorenlexikon, “UTB U 650”