John Deere 3010 or UTB U 650/651?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 3010 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the U 650/651 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The John Deere 3010 suits loader and hydraulic implement work better on this data: 70% (28.0 L/min / 7.4 gpm) more hydraulic flow.
  • The UTB U 650/651 suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
  • The John Deere 3010 suits road haulage better on this data: 11% (3.0 km/h / 1.9 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for John Deere 3010 and UTB U 650/651, with the call on each
Question3010U 650/651Call
Which puts more power through the PTO shaft?47.8 kW (64.1 hp)Traktorenlexikon, “John Deere 3010”47.8 kW (64.1 hp)Traktorenlexikon, “UTB U 650”Not comparableNot comparable on power at the PTO shaft: the 3010 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the U 650/651 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 3010 and the U 650/651.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 3010 and the U 650/651.
Which pumps more oil for implements?68.0 L/min (18.0 gpm)Traktorenlexikon, “John Deere 3010”40.0 L/min (10.6 gpm)Traktorenlexikon, “UTB U 650”AheadThe John Deere 3010 has 70% more hydraulic flow (28.0 L/min / 7.4 gpm) than the UTB U 650/651 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?1,800 kg (3,968 lb)Traktorenlexikon, “John Deere 3010”1,100 kg (2,425 lb)Traktorenlexikon, “UTB U 650”Not comparableNot comparable on three-point lift: the 3010: lift at the hitch ends, as stated by the source (Traktorenlexikon, “John Deere 3010”); the U 650/651: lift at an unstated point, as stated by the source (Traktorenlexikon, “UTB U 650”) — not the same quantity, basis and condition.
Which is heavier, for traction?3,160 kg (6,967 lb)Traktorenlexikon, “John Deere 3010”3,050 kg (6,724 lb)Traktorenlexikon, “UTB U 650”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?4,500 kg (9,921 lb)Traktorenlexikon, “UTB U 650”No figureNo call on maximum permissible mass: no figure on record for the 3010.
Which has the wider choice of gears?7 to 8Traktorenlexikon, “John Deere 3010”10Traktorenlexikon, “UTB U 650”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 3010 and the U 650/651.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “John Deere 3010”27 km/h (16.8 mph)Traktorenlexikon, “UTB U 650”AheadThe John Deere 3010 has 11% more top speed (3.0 km/h / 1.9 mph) than the UTB U 650/651 (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpmTraktorenlexikon, “John Deere 3010”540 rpmTraktorenlexikon, “UTB U 650”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?No figureNo call on PTO independence: not stated for the 3010 and the U 650/651.
Which drives on both axles?2WDTraktorenlexikon, “John Deere 3010”2WD / 4WDTraktorenlexikon, “UTB U 650”AheadThe UTB U 650/651 is available with four-wheel drive; the John Deere 3010 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1962–19641963–1973EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The John Deere 3010 has 70% more hydraulic flow (28.0 L/min / 7.4 gpm) than the UTB U 650/651 (both pump flow, as stated by the source).
  • The John Deere 3010 has 11% more top speed (3.0 km/h / 1.9 mph) than the UTB U 650/651 (both top speed forward, as stated by the source).
  • The UTB U 650/651 is available with four-wheel drive; the John Deere 3010 is two-wheel drive (as stated by the sources).
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 3010 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the U 650/651 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • Not comparable on three-point lift: the 3010: lift at the hitch ends, as stated by the source (Traktorenlexikon, “John Deere 3010”); the U 650/651: lift at an unstated point, as stated by the source (Traktorenlexikon, “UTB U 650”) — not the same quantity, basis and condition.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources