9 material differences · fewer than 12
Tractor oneJohn Deere 2355 (A)1987–1992No measured PTO figureTractor twoVALMET 44001993–1996No measured PTO figure
Which should you choose?
Read our verdict on the 2355 (A) and the 4400 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 2355 (A) | 4400 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66.1 hp | 66.1 hp | — |
| Engine declared | John Deere 4.239 DL-007 or DL-010 | VALMET 320 DS | differs |
| Displacement declared | 3.92 L | 3.30 L | +19% 2355 (A) |
| Maximum torque declared | — | 177 lb·ft · 240 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Dry double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 14.7 gpm · 55.5 L/min | 10.3 gpm · 39.0 L/min | +42% 2355 (A) |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,779 lb · 3,075 kg | 6,151 lb · 2,790 kg | +10% 2355 (A) |
| Wheelbase declared | 89.7 in · 2,279 mm | 83.1 in · 2,112 mm | +8% 2355 (A) |
| Length declared | 145.0 in · 3,683 mm | 149.2 in · 3,790 mm | — |
| Width declared | 89.4 in · 2,270 mm | 80.0 in · 2,032 mm | +12% 2355 (A) |
| Ground clearance declared | 15.7 in · 400 mm | 19.9 in · 505 mm | +26% 4400 |
| Turning radius, braked declared | — | 12.8 ft · 3.90 m | — |
| Fuel tank declared | 88.8 qt · 84.0 L | 100.4 qt · 95.0 L | +13% 4400 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 2355 (A) sources
- Source: Traktorenlexikon, “John Deere 2355”
VALMET 4400 sources
- Source: Traktorenlexikon, “Valmet 4400”
- Source: Traktorenlexikon, “Valmet 465”