12 material differences
Tractor oneJohn Deere 21301972–1979No measured PTO figureTractor twoSOMECA 750 (TD)1971–1976No measured PTO figure
Which should you choose?
Read our verdict on the 2130 and the 750 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 2130 | 750 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 74.0 hp | — |
| Engine declared | John Deere 4.329 DL-01 | O.M.-FIAT CO 3/70 | differs |
| Displacement declared | 3.92 L | 4.56 L | +16% 750 (TD) |
| Maximum torque declared | 188 lb·ft · 255 N·m | 206 lb·ft · 279 N·m | +9% 750 (TD) |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 14.9 mph · 24 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 12.6 gpm · 47.6 L/min | 7.3 gpm · 27.5 L/min | +73% 2130 |
| Pressure declared | 3,989 psi · 275 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,636 lb · 3,010 kg | 6,713 lb · 3,045 kg | — |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 85.7 in · 2,178 mm | 96.1 in · 2,440 mm | +12% 750 (TD) |
| Length declared | 141.7 in · 3,598 mm | 153.9 in · 3,910 mm | +9% 750 (TD) |
| Width declared | 80.3–93.7 in · 2,040–2,380 mm | 72.0 in · 1,830 mm | differs |
| Ground clearance declared | 25.8 in · 655 mm | 20.5 in · 520 mm | +26% 2130 |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 12.5 ft · 3.80 m | +21% 750 (TD) |
| Fuel tank declared | 95.1 qt · 90.0 L | 85.6 qt · 81.0 L | +11% 2130 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 2130 sources
Source
- Source: Traktorenlexikon, “John Deere 2130”
SOMECA 750 (TD) sources
Source
- Source: Traktorenlexikon, “Someca 750”