5 material differences · fewer than 12
Tractor oneHürlimann Prince 445 DT1995–1999No measured PTO figureTractor twoSAME 45 DT1992–2003No measured PTO figure
Which should you choose?
Read our verdict on the Prince 445 DT and the 45 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | Prince 445 DT | 45 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 41.4 hp | 41.4 hp | — |
| Engine declared | MITSUBISHI K4 F-D Turbo | MITSUBISHI K 4 F-DT | differs |
| Displacement declared | 1.49 L | 1.49 L | — |
| Maximum torque declared | — | 74 lb·ft · 100.2 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Prince 445 DT |
| Clutch declared | — | Pedal operated dry single plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 1.8 gpm · 7.0 L/min | 7.9 gpm · 30.0 L/min | +329% 45 DT |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,734 lb · 1,240 kg | 2,227 lb · 1,010 kg | +23% Prince 445 DT |
| Maximum permissible mass declared | — | 5,291 lb · 2,400 kg | — |
| Wheelbase declared | 66.9 in · 1,700 mm | 66.9 in · 1,700 mm | — |
| Length declared | 119.3 in · 3,030 mm | 119.3 in · 3,030 mm | — |
| Width declared | 49.6–53.5 in · 1,260–1,360 mm | 49.4–65.2 in · 1,255–1,655 mm | differs |
| Ground clearance declared | 15.4 in · 390 mm | 15.0 in · 380 mm | — |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 10.8 ft · 3.30 m | — |
| Fuel tank declared | 30.6 qt · 29.0 L | 30.6 qt · 29.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann Prince 445 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 445”
SAME 45 DT sources
- Source: Traktorenlexikon, “SAME Solaris 45”
- Source: Traktorenlexikon, “Lamborghini Runner 450 DT A”