5 material differences · fewer than 12
Tractor oneHürlimann Prince 335 DT1995–1999No measured PTO figureTractor twoHürlimann Prince 435 DT1995–1999No measured PTO figure
Which should you choose?
Read our verdict on the Prince 335 DT and the Prince 435 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 10 fields identical or within 5%, which is not counted as material
| Field | Prince 335 DT | Prince 435 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.6 hp | 34.6 hp | — |
| Engine declared | SLH 500.3 A | MITSUBISHI K4 F-D | differs |
| Displacement declared | 1.57 L | 1.49 L | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | pedal-operated dry single-disc clutch | Pedal-operated dry SDF single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 2.1 gpm · 8.0 L/min | 1.4 gpm · 5.3 L/min | +51% Prince 335 DT |
| Pressure declared | 2,901 psi · 200 bar | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,447 lb · 1,110 kg | 2,601 lb · 1,180 kg | +6% Prince 435 DT |
| Wheelbase declared | 64.2 in · 1,630 mm | 64.2 in · 1,630 mm | — |
| Length declared | 105.9 in · 2,690 mm | 116.5 in · 2,960 mm | +10% Prince 435 DT |
| Width declared | 40.2–53.5 in · 1,020–1,360 mm | 40.2–53.5 in · 1,020–1,360 mm | — |
| Ground clearance declared | 14.2 in · 360 mm | 14.2 in · 360 mm | — |
| Turning radius, braked declared | 9.3 ft · 2.82 m | 9.0 ft · 2.73 m | — |
| Fuel tank declared | 30.6 qt · 29.0 L | 30.6 qt · 29.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann Prince 335 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 335”
Hürlimann Prince 435 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 435”