11 material differences · fewer than 12
Tractor oneHanomag C 2201959–1960No measured PTO figureTractor twoInternational Harvester F-137 D1960–1964No measured PTO figure
Which should you choose?
Read our verdict on the C 220 and the F-137 D → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | C 220 | F-137 D | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 19.6 hp | 19.7 hp | — |
| Engine declared | Hanomag D 621 | INTERNATIONAL HARVESTER FDD-74 | differs |
| Displacement declared | 1.02 L | 1.22 L | +19% F-137 D |
| Maximum torque declared | 58 lb·ft · 78 N·m | 51 lb·ft · 69 N·m | +13% C 220 |
| Transmission | |||
| Top speed declared | 12.3 mph · 19.8 km/h | 11.2 mph · 18 km/h | +10% C 220 |
| Clutch declared | Single dry clutch from Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 3.7 gpm · 14.0 L/min | 3.2 gpm · 12.0 L/min | +17% C 220 |
| Rear PTO speeds declared | 1260 | 542 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,020 lb · 1,370 kg | 2,381 lb · 1,080 kg | +27% C 220 |
| Maximum permissible mass declared | 3,638–4,409 lb · 1,650–2,000 kg | — | — |
| Wheelbase declared | 77.2 in · 1,960 mm | 69.3 in · 1,760 mm | +11% C 220 |
| Length declared | 122.0 in · 3,100 mm | 102.0 in · 2,591 mm | +20% C 220 |
| Width declared | 63.0–73.2 in · 1,600–1,860 mm | 56.3 in · 1,430 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 16.1 in · 409 mm | — |
| Turning radius, braked declared | 8.9 ft · 2.70 m | 8.9 ft · 2.70 m | — |
| Fuel tank declared | 47.6 qt · 45 L | 40.2 qt · 38.0 L | +18% C 220 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag C 220 sources
- Source: Traktorenlexikon, “Hanomag C 220”
- Source: Traktorenlexikon, “Hanomag C 218”
International Harvester F-137 D sources
- Source: Traktorenlexikon, “McCormick F-137 D”
- Source: Traktorenlexikon, “McCormick F-135 D”